User manual UNIVERSAL REMOTE CONTROL AVEX

[. . . ] Congratulations! Congratulations on purchasing Universal Remote Control's AVEXTM R6 Pre--Programmed and Learning remote control. You now have the power to control your entire home entertainment system with one easy--to--use remote. The AVEX R6 can be used with thousands of audio/video components because of the extensive library of codes that have already been programmed into the remote. get ready to sit back, relax, and simplify your home entertainment experience. [. . . ] This number indicates the first digit of the code. Next it will pause for about one second and begin blinking again to indicate the number of the second digit. Then once again it will pause, then blink, o indicate the number of the third digit. Example: One blink, pause, eight blinks, pause, three blinks indicates code number 183. Note that ten (10) blinks represent the number 0. Page 16 Programming Special Advanced Features Programming Multi-Commands to Macro Buttons The AVEX R6 has six Macro buttons (POWER, SYSTEM OFF, A, B, C, D) that are designed to store up to 20 commands in each button. Pressing any one of the Macro buttons will send out the series of commands that are stored in that particular button. MacroPowerTM Total System On/Off MacroPower makes several devices work together by pressing one button. Imagine the convenience of turning on your TV, your DVD player and your Surround Sound receiver by pressing a single button on your AVEX R6. What could normally take three remotes and three button pushes, the AVEX R6 can accomplish with the press of one button. Any of the Power On or the System Off buttons can be programmed for MacroPower control. To set it up, follow these easy steps: STEP 1: To program MacroPower commands for the Power ON button, press the POWER button and the MUTE button at the same time for 2 seconds until one of the component button LED lights turns on. POWER MUTE Page 17 IMPORTANT: You have 30 seconds to perform the next step while you are in programming mode. If you do not press a button within 30 seconds, the component LED light will turn off. The remote will exit the programming mode and you will have to start over. STEP 2: Press the component button you want to turn on and then the POWER button; repeat for all other components in the order you want them to turn on. The component LED lights will blink once each time you press the P OWER button. POWER COMPONENT BUTTONS STEP 3: Once you've entered all the Power On commands, press the CHANNEL UP button to save your MacroPower commands. The component LED lights will blink three times to confirm that the programming has been successfully saved. CHANNEL UP SUGGESTION: Most of the components have the same signal to turn the power On and Off. You may want to program MacroPower only in the POWER button and save the System Off button to turn components On or Off individually. Note: If you want to program MacroPower for the SYSTEM OFF button, repeat the same steps used for Power ON programming. Page 18 Notes regarding programming multi-commands to Macro buttons: · You can program up to 20 commands on each Macro button. · You can program delays in between commands by pressing the PAUSE button. Each press adds a one-half second delay. · Also, if you add the delay time as the first step of Macro commands, the remote will not send the Macro unless the button is held for two seconds. (This is the Press & Hold Function). [. . . ] For example, in most home theaters, to watch television, the user must turn on the TV, then turn on the Cable Box or the Satellite Receiver, then turn on the Surround Sound system for sound. Instead of pressing all of those buttons one at a time, MacroPower enables you to turn on all of these components, in the sequence you want, with one button push. For more information on why and how you should program MacroPower commands, refer to page 17 in this Manual. What if my remote control no longer works from a distance? [. . . ]