User manual UNIVERSAL REMOTE CONTROL CRICKET KIDS REMOTE CONTROL

[. . . ] DO NOT short-circuit the supply terminals. M1192 www. urcsupport. com/cricket 2 3/06/07 Kids Remote 2006. fm Page 3 Tuesday, March 6, 2007 3:52 PM QUICK START Cricket was designed specifically for children ages three or older, with safety and simplicity in mind. Cricket offers a simple means of control over what content your children are exposed to when they watch television. Basic setup is very simple, so you can give the remote to the children in your household to begin using in just a few minutes. Step 1: Installing Batteries Using a Phillips screwdriver, remove the battery cover from the back side of the remote control. [. . . ] When in programming mode, STAR is the 1 key and MOON is the 2 key, VOL + turns the TV volume up. When in programming mode, VOL + initiates programming for TV and VOL initiates programming for cable. When in programming mode, MUTE acts as the SAVE key. CHILD MODE: CH and CH cycles through the ten programmed kids channels on the remote. ADULT MODE: CH and CH cycles the cable box through ALL cable channels. PROGRAMMING MODE: CH and CH cycles through codes to set control of your television or cable box. The eight pre-programmed keys with children network icons jump directly to the channel associated with the icon when in Child mode or Adult mode. While in programming mode, these keys act as number keys 3-0 for programming favorite channels. The three-position switch in the battery compartment is used to set the user or programming mode. CHILD mode is for children and limits them to only have access to the ten programmed channels on the remote. ADULT mode is for older kids or adults and allows access to all cable channels when using channel up/down. P is Programming mode and is used while setting up the remote control to control the TV, Cable box, and to add or modify favorite channels. www. urcsupport. com/cricket 8 Kids Remote 2006. fm Page 9 Tuesday, March 6, 2007 3:52 PM ADDITIONAL PROGRAMMING OPTIONS Locate the three position switch within the battery compartment. Set the switch to the middle position P to enter programming mode. When programming is complete, set the switch to either CHILD user mode or ADULT user mode before replacing the battery compartment door. SETTING TV CONTROL TV control can be set by inputting the code for your brand of TV or via a simple code search. Setting TV control by code input is described in the Quick Start on page 4. With your television ON, and the remote in Programming mode, press the CH key. Press the CH key once per second until the TV turns off. If the TV turns on, press MUTE to save the TV code. If the TV does not turn on, press CH to go to the previous TV code and press MUTE to save once the TV turns on. NOTE: There are over 200 possible codes, so this may take a few minutes. RE-PROGRAMMING FAVORITE CHANNEL KEYS Cricket comes pre-programmed with 8 favorite kids channels assigned to keys 3 through 0. The preprogrammed buttons can be programmed to new channels by following the steps below. CAUTION: This will program over the channel that was pre-programmed by your cable provider! [. . . ] Slide the 3-position switch to CHILD or ADULT mode. Press CH to see if the set-top-box changes channels. If the channel changes, the remote control has been set. If the channel does NOT change, repeat steps 1 through 3 for the next code for that brand of set-top-box. [. . . ]