User manual UNIVERSAL REMOTE CONTROL HOME THEATER MASTER MX-600

[. . . ] Programming the MX-600 to Control Your Components 12 A. Programming Macro Functions To M1, M2, M3, POWER ON and POWER OFF Buttons B. Programming Macro Functions To The Ten Device Buttons 8. Programming Punch Through Functions 32 9. [. . . ] Press the MACRO button next to the LCD screen. 26 7. Press one of the macro buttons, M1-M3, POWER ON or POWER OFF you wish to store your macro on. 4. Press the functional buttons you wish to store in the device macro button you selected, in the order you want them stored. Important: Do not press the MAIN button at the beginning of your macro, or it will not work. You can use the MAIN button at any other step in your macro. Be sure to end your macro on the Device page that you would like it to remain on when the macro is sent in normal use. Store the commands you programmed into the macro button by pressing the Channel Up button. Return to Step #3 until you have programmed all of the Macros that you require. Once you have completed the programming and wish to exit from this mode, press the MAIN button. Exit from the SETUP mode by pressing MAIN button once again. Tip: The M1, M2, M3, POWER ON and POWER OFF macros are "system-wide", meaning they will function the same no matter what device you are in when you use them. 27 7. Programming Macro Functions To The Ten Device Buttons 1. Go to the SETUP mode by pressing the MAIN and ENTER buttons simultaneously for three seconds. Press the MACRO button next to the LCD screen. Press one of the ten device buttons you wish to store your macro on. Press the functional buttons you wish to store in the device macro button you selected in the order you want them stored. Important: Do not press the MAIN button at the beginning of your macro, or it will not work. You can use the MAIN button at any other step in your macro. Be sure to end your macro on the Device page that you would like it to remain on when the macro is sent in normal use. Save the commands you selected to the macro button by pressing the CH UP button. Return to Step #4 until you have programmed all of the Macros that you require. Once you complete the programming and wish to exit from this mode, press the MAIN button. [. . . ] Two-way: Some devices actually send information back to a remote control during use. Most 2-way components can still be controlled via a 1-way remote, although certain workarounds must be used when learning signals. The MX-600 is capable of controlling most 2-way components. Note that the MX-600's RF signal only communicates with the MRF-100 base station (which converts it to Infrared signals). [. . . ]