User manual UNIVERSAL REMOTE CONTROL LIGHTING BROCHURE

[. . . ] Native Lighting Control Control Dimmers, Lamp Dimmers and Switches Directly from URC Remote Controls URC Lighting Control by LutronTM Give Your Clients Control of the Lights in the Room They're In. . . greenbriar bluestone Lighting Control backed by two of the biggest names in the business-Universal Remote Control and Lutron Electronics-both relentlessly committed to quality, reliability, service and support. URC-Lutron Compatible Remotes Model MX-6000 MX-3000 Black MX-3000 MX-980 MX-950 MX-900 MX-880 MX-850 MX-810 MX-650 MX-450 MX-350 MX-350N TX-1000 KP-900 Yes=Preprogrammed. *Some models require Learning. Yes Yes Yes* Yes Yes* Yes* Yes Yes* Yes Yes* Yes Yes* Yes* Yes* Yes MX-6000 MX-980 MX-880 MX-810 MX-450 control the dimmers & switches directly via RF! MX-3000B KP-900 URC Remotes URC Lighting Control by LutronTM Add Lighting Control to Every Job. . . Native Control No interface required when used with URC remotes. URC remotes control the dimmers and switches directly via RF. [. . . ] With one address stored in all dimmers and one unique address stored in each dimmer: Eight (8) Lighting Scenes involving all RF Dimmers and RF Switches. Each: On, Off, Brighten and Dim individually. With two addresses stored in all dimmers and one unique address stored in each dimmer: Sixteen (16) Lighting Scenes involving all RF Dimmers and RF Switches. Each: On, Off, Brighten and Dim individually. Ganging and Derating Min Load Incandescent Dimmer MLV Dimmer Wallbox Switch Lamp Dimmer Accessory Dimmer Accessory Switch 60W 40W/VA 10W 25W No fins broken 600W 600VA/ 450W* 6A light/ 3A fan** 300W 8. 3A 8. 3A 1 side of fins broken 500W 500VA/ 400W* 5A light/ 3A fan** Both sides of fins broken 400W 400VA/ 300W* 3. 5A light/ 3A fan** *Note: The maximum lamp wattage is determined by the efficiency of the transformer, with 70­85% as typical. For actual transformer efficiency, contact either the fixture or transformer manufacturer. The total VA rating of the transformer(s) shall not exceed the VA rating of the dimmer. **Note: When controlling a combined fan and light load, the total cannot exceed 3A. Build a small lighting control system one dimmer at a time. . . Lighting Control uses Wall Dimmers, Lamp Dimmers and Switches-rated for the correct Load ­ to create Scenes for different Activities. Load The load on the dimmer (or switch) is determined by the total wattage of ALL of the lights controlled by the dimmer, i. e. , everything that is on that circuit. The load is calculated by adding together the wattage of each light. Each light's highest allowable wattage ("worse case") light bulb is used for purposes of calculation. For example, even if the client currently has a 60 watt bulb installed, if the fixture is labeled "100 Watts Maximum" they might install a 100 watt bulb. Therefore, you must use 100 Watts as the wattage when calculating the load on the dimmer. (This information is provided for specification purposes only-do not install high voltage wall dimmers or switches unless you are legally and technically qualified to do so. ) Scene A group of Loads controlled altogether and at the same time. A Scene can include a multiple of RF Switches and/or RF Dimmers. Every RF Dimmer in a scene operates at a stored brightness setting. Every RF switch in a scene either turns on or off. [. . . ] Lamp Dimmers are available in White and Black only. Contact your Sales Representative or Distributor for more details and availability information. Available exclusively from: Universal Remote Control, Inc. 500 Mamaroneck Avenue, Harrison, NY 10528 Phone: (914) 835-4484 Fax: (914) 835-4532 www. universalremote. com REV: 100108 stone taupe terracotta turquoise stainless steel (wallplates only) [. . . ]