User manual UNIVERSAL REMOTE CONTROL UR3L-SR4 SPECS SHEET

[. . . ] If there are more than one three-digit number listed for your brand, try one code number at a time until your equipment turns off. *Note : You can verify that you have selected the correct code by pressing the [POWER] button. STEP4 Store the three-digit code by pressing the same [DEVICE] button once again. The device LED will blink twice to confirm that the code has been stored. [. . . ] STEP3 Press any button on the UR3L-SR4 that you want to teach a command to. For example, if you want to teach the [MUTE] button, press the [MUTE] button. STEP4 Press and hold the [MUTE] button on the other remote until the UR3L-SR4 Component LED light blinks twice. *Note : The LED will blink 5 times if there was an error in the learning process. Continue learning other buttons by repeating STEPS 3 and 4. STEP5 Once you have completed teaching UR3L-SR4 all desired commands for that Component, save the learned commands by pressing the [COMPONENT] and [INPUT] buttons simultaneously until the Component LED blinks 3 times. Now test all the buttons to make sure they learned correctly. F. Erasing a Single Learned Command STEP1 Press the [COMPONENT] and [INPUT] buttons simultaneously for 3 seconds until the Component LED light turns on. STEP2 Press and hold the button you want to erase for 3 seconds. The Component LED will blink twice to confirm the erasure. STEP3 To exit, press and hold both the [COMPONENT] and [INPUT] buttons simultaneously until the Component LED blinks 3 times. 5 G. Erasing All Lear ned Commands fr om One Component STEP1 Press the [COMPONENT] and [INPUT] buttons simultaneously for 3 seconds until the Component LED light turns on. STEP2 Press and hold both the [COMPONENT] button you want to erase and the [PAUSE] button for 5 seconds. The Component LED will blink twice to confirm the erasure. STEP3 To exit, press and hold both the [COMPONENT] and [INPUT] buttons simultaneously until the Component LED blinks 3 times. H. Programming the All Off Button This allows you to program the All Off button so it can send up to three power On/Off commands with one button press. STEP2 Press the [All OFF] button and the [OK/SEL] button simultaneously for 3 seconds. The [CBL] button will turn on for 30 seconds. STEP3 Press the first [COMPONENT] button you want to store in the [ALL OFF] button and then the [POWER] button. Repeat this for other Components until you have stored all the desired power commands into the [ALL OFF] button. STEP4 Press the [CH+] button to save the power commands you stored. The [CBL] button will blink twice to confirm the commands have been saved. I. [. . . ] Example : If you wish to have the volume and mute keys operate your TV, press the [TV] button in Step3. K. Assigning the Channel keys to a Different Device CBL : CBL TV : CBL DVD : DVD STEP1 Press the [OK/SEL] button and [TV] button simultaneously for three seconds. The device LED Will turn on for 30 seconds. The next step must be performed while the LED in on. [. . . ]