User manual UNIVERSAL REMOTE CONTROL UR4-P360 TIME WARNER CABLE

[. . . ] *Tip : You can verify that you selected the correct code by pressing the [MUTE] button. The TV should either turn on or turn off. STEP4 Press the same [DEVICE] button to store the code. The Device LED will blink twice to confirm that the code has been stored. D. [. . . ] STEP2 Check battery polarity carefully, and install the batteries as shown in the illustration below. STEP3 Replace the battery compartment cover. STEP1 Press the [CBL] button to select the CABLE mode. STEP2 Press the [ ] button and [SELECT] button simultaneously for 3 seconds. The [CBL] device LED will turn on for 20 seconds. * F. Program the Volume Controls. By following the steps below, you can program the volume controls (Volume UP, Volume Down and MUTE) to your TV, VCR and Audio. The default volume control settings on the remote control is TV volume control. If you wish you can control the volume via your cable box or audio equipment. Use the following steps to change the volume control settings: STEP1 Press the [CBL] button and the [SELECT] button simultaneously for 3 seconds. *Tip : The device LED will light on for 20 seconds. The next step must be entered while the LED is on. STEP3 Press the [ CBL ], [ AUD ] (whichever applicable) button. The [CBL] device LED will blink twice to confirm the programming. To return to original state: If you wish to restore the TV volume control in CABLE mode, repeat the above steps by pressing [ TV ] button in STEP3 Press up to 10 buttons you wish to store. The [CBL] button LED will blink once for each command entered. STEP4 Press the [CH+] button to store the functions that are selected. The [CBL] device LED will blink twice to confirm the storage of functions. C. To Find the Three Digit Code Number That was Stored in the Device. STEP1 Press the [DEVICE] button (TV, VCR or AUD) you wish to verify and the [SELECT] button simultaneously for 3 second. *Tip : The device LED will light on for 20 seconds. The next step must be entered while the LED is on. The device LED will blink number of times indicating the number of each digit of the code number. Each digit is separated by a 1 second pause of the LED being turned off. Example : One blink, three blinks and eight blinks with an interval of 1 second of LED being turned off, indicates the code number 138. [. . . ] STEP3 Point the remote control toward the equipment and enter the three-digit code number assigned to your brand from the code tables. If the three-digit code numbers assigned to your brand do not turn off your equipment or the code tables do not list your brand, you can use the Auto Search Method to find the correct three-digit code number for your equipment by the following steps: STEP1 Turn on the equipment you wish to operate. STEP2 Press the [DEVICE] button (TV, VCR or AUD) to be programmed and the [SELECT] button simultaneously for 3 seconds. *Tip : The device LED will light on for 20 seconds. The next step must be entered while the LED is on. E. [. . . ]