User manual UNIVERSAL REMOTE CONTROL UR5U-8500L

[. . . ] The Component LED light will blink twice to confirm that the code was successfully stored. Now, program the rest of your Components by repeating STEPS 1-5. *Note : If the Pre-Programmed Method did not work, or if the Code Tables do not list your Component brand, use the Auto-Search Method as explained in Section B. STEP5 Save the code. (Same as for 3-Digit Code STEP5 Once you have found the correct 3-digit Programming Method - Section A). [. . . ] STEP3 Replace the battery compartment cover. If you wish to store the CBL volume control in CBL mode, use the following steps. STEP1 Press the [CBL] button and the [OK/SEL] button simultaneously for 3 seconds. The [CBL] Component LED will turn on for 30 seconds. The Component LED will blink twice to confirm the programming. To return to original state: If you wish to restore the TV volume control in CBL mode, repeat the above steps but press [TV] in STEP3 . H. Programming a `Macro' or Favorite Channel In CBL mode, the M1, M2 and HELP buttons can be programmed to act as a `Macro' or Favorite Channel button. This allows you to send up to 10 commands with one button press. STEP1 Press the [CBL] button to select the CBL mode. STEP2 Press the M1, M2 or HELP button and [OK/SEL] button simultaneously for 3 seconds. The [CBL] Component LED will turn on for 30 seconds. STEP3 Press up to 10 buttons you wish to store. The [CBL] Component LED will blink once for each command entered. STEP4 Press the [CH+] button to store the commands that were selected. The [CBL] Component LED will blink twice to confirm the storage of commands. F. Programming Channel Control You can program the channel controls (Channel Up, Channel Down and Last) from one Component to operate in another Component mode. Default channel control settings on the remote control are as follows: CBL : CBL DVD : DVD T V : CBL AUX : AUX VCR : CBL D. AUX Function: Programming a 5 th Component You can take advantage of the AUX function to program a 5th Component such as a second TV, VCR, DVD or Audio Component. STEP1 Turn on the 5th Component you want to program (TV, VCR, DVD or Audio) using your old remote. STEP2 Press the [AUX] button and the [OK/SEL] button simultaneously for 3 seconds. The [AUX] Component LED will turn on for 30 seconds. STEP3 Press the [COMPONENT] button you want to setup. Point the remote control toward the Component and enter the 3-digit code number assigned to your brand. *Note : If the 3-digit code number you just entered is the correct number, the Component will turn Off. [. . . ] The [TV] Component LED will turn on for 30 seconds. The Component LED will blink twice to confirm the programming. To return to original state: If you wish to restore the CABLE channel control in TV mode, repeat the above steps but press [CBL] in STEP3 . I. Low Battery Warning When the batteries are low and need to be replaced with fresh batteries, the Component LED lights will blink 2 times in sequence whenever a [POWER] button is pressed to turn on equipment. J. [. . . ]