User manual UNIVERSAL REMOTE CONTROL URC-R6 SPECS SHEET

[. . . ] Remote Control Owner's Manual AVEX R6 Page 1 Congratulations! Congratulations on purchasing Universal Remote Control's AVEX R6 Pre--Programmed and Learning remote control. You now have the power to control your entire home entertainment system with one easy-to--use remote. The AVEX R6 can be used with thousands of audio/video components because of the extensive library of codes that have already been programmed into the remote. get ready to sit back, relax, and simplify your home entertainment experience. [. . . ] STEP 2: Press the `A', `B', `C' or `D' button and the MUTE button at the same time for 2 seconds until the CBL component LED turns on. IMPORTANT: You have 30 seconds to perform the next step while you are in programming mode. If you do not press a button within 30 seconds, the component LED light will turn off. The remote will exit the programming mode and you will have to start over. MUTE A BUTTON STEP 3: Using the Number Pad, punch in the Channel number of the Favorite Channel that you want to store in the Macro button. The Cable component LED light will blink once for each button pressed. STEP 4: Press the CHANNEL UP button to store the commands entered. The CBL component LED will blink three times to confirm the programming. CHANNEL UP Page 17 More Favorite Channels You can also use the "A, B, C and D" buttons to program favorite channels. Each button can program up to 5 favorite channels (or a total of 20 button presses), but you're not limited to using these buttons for only that. You can record any series of button presses into a macro. This is great switching video or audio sources. Here is an example of how to program a macro on the "A" button with three favorite channels. We'll use "25, 50, and 75. " STEP STEP 1: Press the device you are getting channel control from. 2: Press and hold the "A" button and "Mute" button at the same time until a device button lights up. 15: Press "Channel Up" to save macro. STEP STEP STEP STEP STEP STEP STEP STEP STEP STEP STEP STEP STEP Note: Pressing the "Select" button just assures the quickest response from the Cable box. Pressing "Stop" allows you to program several favorite channels on one button. Now, the first press of the "A" button will change the channel to "25. " The second, to "50" and the third, to "75. " Then the sequence starts all over again. Page 18 SimpleSoundTM Total System Volume Control SimpleSound is one of the most exciting features of the AVEX R6. It gives you total volume control over ALL the components in your system, even those that do not have built--in volume control, such as TIVO, DVD and VCR. SimpleSound saves you the hassle and inconvenience of constantly switching between component modes just to control volume. First you should identify which device in your system will be used to deliver sound. In a basic system, the sound may come from your TV speaker. In a more advanced system, the sound may come from your audio components (such as a Surround Sound Receiver or Home Theatre system). Here's how: STEP 1: Press and hold the button that corresponds to the Component you want to add volume control to (such as a DVD or VCR) and the SELECT (SEL) button at the same time for about three seconds until the component LED light turns on. [. . . ] For more information on why and how you should program MacroPower commands, refer to page 17 in this Manual. What if my remote control no longer works from a distance?Replace the batteries with new Alkaline batteries. Who can I contact for more answers?The Universal Remote Control technical support and customer service staff are ready to answer any questions you might have. [. . . ]