User manual UNIVERSAL REMOTE CONTROL

[. . . ] Transparencies, short edge feed, one at a time · Custom Sizes: Must be defined in driver before printing: see your on-line User's Guide. Load face up, top edge into the printer. envelopes · Load print side up (flap down) with top edge aimed into the printer. Provides straight-through, curl-free print path for transparencies, envelopes, labels and heavy paper. [. . . ] Note If the sheet is not well advanced, it will be removed in step 7. Do not touch the green image drum surface or expose it to light for more than 5 minutes. Cover them to protect them Fuser, pull the fuser release lever (1) forward, then remove the sheet. If the sheet is difficult to remove from the fuser: Caution!If it is not already in use, lower the rear exit tray If you are not using the rear exit tray, close it. Replace the image drums/toners, being careful to install them in the proper sequence. Reach in and push the fuser release lever (1) and pull the sheet out from the back. Lower the printer cover to Protect the image drums from light, but do not latch it. For printers equipped with the optional duplexer: Open the duplex unit cover and remove any sheets. If it is not already open, lower The MP Tray, then lift the inside cover release (1) and open the inside cover. If you are not using it, close Pull out the paper tray and For printers equipped with the optional paper tray(s): Pull out the optional paper tray and remove any jammed paper. Note These messages should not appear if the procedure described under "Clearing Media Jams" starting on page 16 is followed when clearing paper jams. Additional paper is jammed behind the front cover. Additional paper is jammed in the indicated tray TTTT: 631 = Tray 1 632 = (optional) Tray 2 633 = (optional) Tray 3 Pull out the tray and remove the jammed paper. For more information, see "Clearing Media Jams" starting on page 16, or press the HELP button on the printer control panel. Additional paper is jammed around the top cover. Error Codes: 638 = paper transport path 639 = paper exit path 640 = duplex entry path For more information, see "Clearing Media Jams" starting on page 16, or press the HELP button on the printer control panel. Appears on the second line of the display to indicate that a color print job sent by a user who is not permitted to print color jobs has been printed in monochrome instead. If the one of the utilities is engaged, messages may appear on the second line of the display regarding print jobs from users who have restricted access or no access to the printer. to clear the message , press the On Line button. If you have any questions, contact your System Administrator. Appears on the second line of the display to indicate that a color print job sent by a user who is not permitted to print color jobs has been rejected because the printer was unable to print the job in monochrome instead. [. . . ] Gaining access through the gap left by Tray 1, wipe the two paper feed rollers (1) with a soft cloth lightly moistened with water. Never use solvents or strong detergents on the cabinet: they could cause damage. Use a soft, damp cloth to wipe the housing clean. Consult the store where you purchased your printer. [. . . ]