User manual US ROBOTICS 3CP5610 INSTALLATION GUIDE

[. . . ] The CS light should illuminate. NOTE: If the CS light does not illuminate or other lights illuminate, make sure that only DIP switches 3, 5, and 8 are in the down position. (The DIP switches are located next to the phone jacks on the back of the modem. ) You may also be using the wrong serial cable or the wrong power supply. See the "Before You Begin" section at the beginning of this Installation Guide for more information. 6 Verify that the modem is properl installed. [. . . ] then click Type A:\ in the box and then click . If your floppy drive uses a different letter, type that letter in place of "A". If you have Windows 95 Version B: When the "Update Device Driver Wizard" screen appears, click . When the "Insert Disk" screen appears, make sure you have the floppy disk inserted into the computer's floppy drive. When the "Copying Files" screen appears, type A:\ in the box and click . If you have Windows 98: Turn your computer on. When the "Add New Hardware Wizard" screen appears, insert your driver diskette into your . Select "Search for the 3. 5 inch drive and click best driver for your device" and click . Put a check in the box next to "Floppy disk drives. " If the location of your 3. 5 inch drive is not a:\ change it on the bottom section of this screen. Click . Before You Before You Begin Use the right cable. To install the modem, you need an RS-232 serial cable. This is also known as a "modem cable" or a "PC to modem" cable. Do not use a null modem cable or a printer cable. Look at the COM port on the back of your computer to determine the type of cable you need. 7 Install Connections Install the Conne ctions CD and register your modem. Click and then click . If your D:\setup. exe and then click CD-ROM drive uses a different letter, type that letter in place of "D". 3 Connect Conne ct the modem to an analog phone line. Plug one end of the included phone cord into the TELCO jack on the modem (labeled an analog phone jack. WARNING: Many offices and some homes have digital phone lines. [. . . ] Uploads from users to server equipment travel at speeds up to 31. 2 Kbps. An analog phone line compatible with the ITU-T 56K standard or x2 technology, and an Internet provider or corporate host site compatible with the ITU-T 56K standard or x2 technology are necessary for these high-speed downloads. Robotics are registered trademarks; x2 andConnections are trademarks of 3Com Corporation. [. . . ]