User manual US ROBOTICS 56K FAXMODEM USB INSTALLATION GUIDE FOR WINDOWS REV 1.1

[. . . ] No part of this documentation may be reproduced in any form or by any means or used to make any derivative work (such as translation, transformation, or adaptation) without written permission from U. Robotics Corporation reserves the right to revise this documentation and to make changes in the products and/or content of this document from time to time without obligation to provide notification of such revision or change. Robotics Corporation provides this documentation without warranty of any kind, either implied or expressed, including, but not limited to, implied warranties of merchantability and fitness for a particular purpose. If there is any software on removable media described in this documentation, it is furnished under a license agreement included with the product as a separate document, in the hard copy documentation, or on the removable media in a directory file named LICENSE. [. . . ] The PWR light will not illuminate until the drivers are installed. If the drivers are installed, then check the following possible solutions. Possible solution: Make sure the USB cable is connected and secure at both ends. possible solution: Try a different USB port on the computer. If a USB hub is being used, try plugging into the USB port on the computer. Possible solution: If the modem has worked previously and you removed the USB cable from the computer and then reattached it, try another USB port. It may have been set up originally on the other USB port. You should notice some minimal activity from your computer such as hard disk activity or an hourglass icon for a few seconds when you insert or remove a USB cable from the computer or the USB device. If you do not see anything, your system may not be properly communicating with the USB ports. possible solution: Your USB port may not be enabled. To ensure USB is enabled on your system in Windows 98 or Me, click Windows Start, Settings, and then Control Panel. double-click the Systems icon and then click the Device Manager tab. To ensure USB is enabled on your system in Windows 2000, click Windows Start, Settings, and then Control Panel. doubleclick the Systems icon , click the Hardware tab , and then click the Device Manager button. All Windows users, if USB is enabled, there will be a USB icon and the words "Universal serial bus controller" under the Computer icon. If USB is not enabled, you will need to enable USB in the system's BIOS. check with your computer manufacturer's documentation for instructions. Once your USB port has been enabled in your system's BIOS, Windows will automatically detect and install USB support when it restarts. Possible solution: Your communications software may not function properly if you have more than one version of the software installed, you are using an older version, or you have more than one communications software package installed on your system. We highly recommend using the communications software provided with your modem on the Installation CD-ROM. Possible solution: You may not have the correct modem type selected in your software or in Windows. When Control Panel opens, click Phone and Modems and then click the Modem tab. [. . . ] 3 CUSTOMER assumes full responsibility to properly install and configure this product and to ensure proper installation, configuration, operation and compatibility with the operating environment in which this product is to function. ROBOTICS or its authorised reseller) for any warranty claims to be authorised. ROBOTICS Service Centre within the applicable warranty period to obtain warranty service authorisation. 2 Customer must provide Product Model Number, Product Serial Number and dated Proof of Purchase (copy of original purchase receipt from U. [. . . ]