User manual US ROBOTICS 56K SERIAL CONTROLLER FAXMODEM QUICK INSTALLATION GUIDE

[. . . ] If you are unable to locate a copy, please contact U. UNITED STATES GOVERNMENT LEGEND If you are a United States government agency, then this documentation and the software described herein are provided to you subject to the following: All technical data and computer software are commercial in nature and developed solely at private expense. 101(a) and as such is provided with only such rights as are provided in U. Technical data is provided with limited rights only as provided in DFAR 252. [. . . ] If your modem still does not work, you may need to remove it and reinstall it in another available slot. Check your modem again using Control Panel as described previously. Step 4: Install software and register your modem. The Setup Wizard on the CD-ROM guides you through installing the program group (including Internet Call Notification, ControlCenter, and optional voice faxmodem software) and registering your modem. NOTE: If the Installation CD-ROM interface does not run automatically, click Windows Start and then click Run. If your CD-ROM drive uses a different letter, type that letter in place of "D. " NOTE: If you would like to use the voice functionality of this modem, you must install the voice software. This software can be found on the Installation CD-ROM in the Software section. Follow the on-screen instructions to register your modem and to view the warranty information. If the Installation CD-ROM interface does not run automatically, click Windows Start and then click Run. If your CD-ROM drive uses a different letter, type that letter in place of "D. There should be a place in the Setup section of your software that addresses port settings. Make sure the software's port settings match those for your modem. To check which COM port your modem is using, click Windows Start, Settings, and Control Panel. double-click Modems , select your modem , and select Properties. Check your communication software's documentation for instructions about adjusting the port settings in your software. Possible solution: You may not have the correct modem type selected in your software or in Windows. You can also add, remove, or view the properties of modems from this window. The USRobotics modem you have installed should be present in the list of installed modems. If none of the modem descriptions in the list matches your USRobotics modem or no modems are listed, your modem is not installed properly. Possible solution: If you are using software that uses a Windows modem description and you had a previous modem installed, you may need to update your software's setting to reflect the use of the USRobotics V. My modem won't dial out or doesn't answer incoming calls. [. . . ] CUSTOMER is specifically advised to make a backup copy of all software provided with this product. CUSTOMER assumes full responsibility to properly install and configure this product and to ensure proper installation, configuration, operation and compatibility with the operating environment in which this product is to function. ROBOTICS or its authorised reseller) for any warranty claims to be authorised. ROBOTICS Service Centre within the applicable warranty period to obtain warranty service authorisation. [. . . ]