User manual US ROBOTICS USR2450 REFERENCE GUIDE

[. . . ] Wireless Access Point Windows 95, 98, 2000, Me, NT, and XP Companion Reference Guide R24. 0258. 00 Step 1. Connect the Wireless Access Point · Use the Ethernet port and an RJ-45 cable to connect the Wireless Access Point to one of the following devices: a cable or DSL modem with routing capabilities, a hub, a bridge, an existing Ethernet LAN, or a router. · · Attach the antenna to the Wireless Access Point. Attach the power supply to the Wireless Access Point. Step Two: Install your software Note: You only need to install this software on the PC or laptop that was originally connected to your modem, bridge, router, or hub. Insert your U. S. [. . . ] When this is performed, the Wireless Activity LED will blink. If you press the Reset button a second time, all setting information except for the password and the encryption data will be cleared. If this is done, the Wireless Link Indicator will blink. When you are finished changing your password, click Apply for the new password to be activated. For security purposes, it is recommended that you change your password after you successfully log in. Anytime you reset the Wireless Access Point, your password will revert to the default setting. When you are finished viewing or changing your Wireless Access Point information, click Logout. You will then be asked if you are sure that you want to logout. Click Yes. Troubleshooting My computer does not recognize the Wireless Access Point after I changed the settings. Possible Solution: Ensure that the WLAN Configuration utility is installed for your Wireless Access Point and that the Configuration utility is installed and functioning for your Wireless Access PC Cards or PCI Adapters. Possible Solution: Ensure that you are contacting the correct Wireless Access Point and using the correct MAC address. Possible Solution: Ensure that the correct password and encryption option are being used. If you changed the settings in the configuration of the Wireless Access Point, you must also change the settings of every Wireless Access PC Card or PCI Adapter attached to this network. The settings of the Wireless Access PC Cards or PCI Adapters must match the new settings of the Wireless Access Point. I am unable to communicate with the Wireless Access Point. Possible Solution: Be sure that each Wireless PC Card or PCI Adapter that you want to connect to the wireless network is set to Infrastructure mode within the Configuration Utility. If your Wireless Access PC Cards or PCI Adapters are not set to Infrastructure mode, they will not be able to communicate with the Wireless Access Point. Possible Solution: Your Wireless Access Point may not be responding. Try resetting the Wireless Access Point to reactivate it. While holding in the Reset button, unplug the power adapter from the Wireless Access point and then plug it back in. Release the Reset button and then press it once. This will restore the factory default settings. [. . . ] Robotics Corporate Service Center or an Authorized U. S. Robotics Service Center within the applicable warranty period to obtain warranty service authorization. Robotics or its authorized reseller may be required. Robotics' Corporate Service Center must be pre-authorized by U. S. [. . . ]