User manual US ROBOTICS USR5410 INSTALLATION GUIDE

[. . . ] 802. 11g Wireless Turbo PC Card Installation Guide Package Contents: - 802. 11g Wireless Turbo PC Card - Installation CD-ROM - Quick Installation Guide Install your software and drivers Note: You will need to install this software on all the laptops you plan to wirelessly network together. Robotics Installation CD-ROM into your CD-ROM drive. Note: If your CD-ROM does not automatically launch, click Windows Start, Run, and type D:\setup (if your CD-ROM drive uses a different letter, type that letter in place of "D") and click OK. The Installation CD Graphic User Interface (GUI) will appear on your screen. [. . . ] Robotics products can also be answered by technical support specialists. Country United States Canada Voice (801) 401-1143 (801) 401-1143 Online http://www. usr. com/emailsupport http://www. usr. com/emailsupport Support Hours 9:00 A. M. - 5:00 P. M. , Monday - Friday CST 9:00 A. M. - 5:00 P. M. , Monday - Friday CST 4. 2 4. 3 4. 4 4. 5 For current support contact information, go to the following Web site: http://www. usr. com/support 4. 6 4. 7 4. 8 5. 0 5. 1 Regulatory Approvals FCC Declaration of Conformity This device complies with FCC Rules Part 15. Operation is subject to the following two conditions: This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy. If this equipment is not installed and used in accordance with the manufacturer's instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. The use of shielded cables for connection of the monitor to the graphics card is required to assure compliance with FCC regulations. Modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator and your body. UL Listing/CUL Listing This information technology equipment is UL-Listed and CUL-Listed for the uses described in the User Guide. Industry Canada Statement This equipment complies with the Industry Canada Spectrum Management and Telecommunications policy, RSS-210 standard, Low Power License-Exempt Radio Communication Devices. Operation is subject to the following two conditions: 1. This device may cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device. I received a message that my laptop computer shares a name with or there was an IP address conflict with another computer on the wireless network. Possible Solution: Each computer on the wireless network must have a unique name and IP address. [. . . ] ROBOTICS will make reasonable effort to ship repaired or replaced product or part to CUSTOMER, at U. S. ROBOTICS expense, not later than TWENTY ONE (21) DAYS after U. S. ROBOTICS receives the authorized CUSTOMER return at an authorised U. S. ROBOTICS shall not be liable for any damages caused by delay in delivering or furnishing repaired or replaced product or part. [. . . ]