User manual US ROBOTICS USR5633B RELEASE NOTE

[. . . ] Robotics Installation CD-ROM. Configure the basic connection settings Congratulations!You have finished installing your hardware and your drivers!The 802. 11g Wireless Turbo PCI Adapter will connect to an existing wireless network or other wireless networking products in the area. You should now see a small icon for the Configuration Utility in the system tray by your clock on your computer desktop. [. . . ] Possible Solution: Verify that the 802. 11g Wireless Turbo PCI Adapter is properly installed. If you continue to experience problems, uninstall the 802. 11g Wireless Turbo PCI Adapter and repeat the installation procedure. Possible Solution: If you are attempting a peer-to-peer connection, verify that each wireless adapter is set to 802. 11 Adhoc mode. If you are using a Wireless Access Point, verify that each wireless adapter is set to Infrastructure mode. My 802. 11g Wireless Turbo PCI Adapter does not see my Access Point in the list when I scan for it. Possible Solution: If you create a wireless connection with the 802. 11g Wireless Turbo PCI Adapter but are experiencing poor link quality, check the positioning of the 802. 11g Wireless Turbo PCI Adapter. Long distances, multiple floors, or steel or concrete walls can diminish the link quality. If possible, reposition the 802. 11g Wireless Turbo PCI Adapter to reduce the effect of any of these obstacles. In addition, check any physical connections between the Access Point and your modem, router, hub, LAN, or switch. Possible Solution: If your Access Point is not broadcasting an SSID, it will not appear during a scan by your 802. 11g Wireless Turbo PCI Adapter. The client will need to be manually configured. - 5:00 P. M. , Monday - Friday CST 9:00 A. M. - 5:00 P. M. , Monday - Friday CST For current support contact information, go to the following Web site: http://www. usr. com/support Regulatory Approvals FCC Declaration of Conformity This device complies with FCC Rules Part 15. Operation is subject to the following two conditions: This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy. If this equipment is not installed and used in accordance with the manufacturer's instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. [. . . ] The enclosed Proof of Purchase will be inspected for date of purchase and place of purchase. ROBOTICS may deny warranty service if visual inspection of the returned product or part does not match the CUSTOMER supplied information for which the RMA was issued. 4. 6 Once a CUSTOMER return has been unpacked, visually inspected, and tested U. S. ROBOTICS will, at its sole discretion, repair or replace, using new or reconditioned product or parts, to whatever extent it deems necessary to restore the product or part to operating condition. [. . . ]