User manual US ROBOTICS USR997900

[. . . ] 10/100 Mbps Network Card Fast Ethernet User Guide model number USR7900 part number R24. 0209. 00 Introduction The U. S. Robotics Ethernet Network Card is a dual-speed Ethernet card for PCI local bus-compliant computers. A true Plug and Play device, this card is auto-configurable upon power up and also supports auto-negotiation to automatically select the optimum speed and communication mode of an attached device. The U. S Robotics Ethernet Network Card complies with ACPI and OnNow PC98/PC99 and also supports Remote LAN Wakeup. [. . . ] Check for any hardware problems, such as physical damage to the card's edge connector. Try the card in another PCI bus-master slot. Robotics Ethernet Network Card that is known to operate correctly. Possible Solution: Check to see if there is a resource conflict in the PCI configuration. Possible Solution: If there are other network adapters in the computer, they may be causing conflict. Remove all other adapters from the computer and test the U. S. Robotics Ethernet Network Card separately. Possible Solution: Check for a defective computer or PCI bus by trying the adapter in another computer that is known to operate correctly. I am unable to access the network or the Internet. There may be a network or Internet connection problem if the LED on the card's bracket does not illuminate or if you cannot access any network or Internet resources from the computer. Check the following items: Possible Solution: Make sure you are using Category 5 cable for 100 Mbps connections, and that the length of any cable does not exceed 100 m (328 ft). Inspect all network cables and connections. Make sure the network cable is securely attached to the card's connector. Possible Solution: Make sure the correct network card driver is installed for your operating system. If necessary, try reinstalling the driver. Possible Solution: If the network card's speed or duplex mode has been configured manually, make sure it matches that of the attached network device port. It is recommended to set the card to auto-negotiation when installing the network driver. Possible Solution: The port on the network device that the card is attached to may be defective. Possible Solution: If you cannot access a Windows or NetWare service on the network, check that you have enabled and configured the service correctly. If you cannot connect to a particular server, be sure that you have access rights and a valid ID and password. Possible Solution: If you cannot access the Internet, check your network settings and verify that TCP/IP is installed and properly configured. Support Resources If you have not fixed your problem after trying the suggestions in the "Troubleshooting" section, you can receive additional help via one of these convenient resources: World Wide Web Contains useful product information, documents, and manuals. Log on to : http://www. usr. com/support Are you still having problems?1. ) Call the dealer who sold you the network card The dealer may be able to troubleshoot the problem over the phone or may request that you bring the network card back to the store for service. Robotics Technical support department Technical questions about U. S. [. . . ] Robotics or its authorised reseller may be required. Robotics Corporate Service Centre must be pre-authorised by U. S. Robotics with a Service Repair Order (SRO) number marked on the outside of the package, and sent prepaid and packaged appropriately for safe shipment, and it is recommended that they be insured or sent by a method that provides for tracking of the package. The repaired or replaced item will be shipped to Customer, at U. S. [. . . ]