User manual VALBERG 4D 511 F DX625C

[. . . ] Precautions shall be taken to prevent fall of the handle from causing any personal injury. Levelling feet Schematic diagram of the levelling feet l H (The picture above is only for reference. The actual configuration will depend on the physical product or statement by the distributor. Turn the feet clockwise to raise the refrigerator; b. [. . . ] Placed according to the position in the picture above are the most energy efficient. NOTE: Storage of too much food during operation after the initial connection to power may adversely affect the freezing effect of the refrigerator. Foods stored shall not black the air outlet; or otherwise the freezing effect will also be adversely affected. Display When electrify the refrigerator, the display screen will total display for 3 seconds. Meanwhile the starting up bell rings and then the screen enters the normal display of the operation. The first time for using the refrigerator, the default set temperature of refrigerating chamber and freezing chamber is 5 °C/-18 °C respectively. When the error occurs, the display shows the error code (see next page); during normal running, the display shows the set temperature of the refrigerating chamber or freezing chamber. under normal circumstances , if there is no operation on display panel or door Opening action within 30s, then the display is Iock, and the sate goes out. In the unlocked state, long press the Iock button For 3 seconds, enter the Iock state. The logo goes outand buzzer sounds, il means the display panel is locked, at this time, button operation cannot be implemented; In the locked state, long press the Iock button For 3 seconds, enter the unlocked state. The logo lights up and buzzer sounds, it means the display panel is unlocked, at this time, Setting temperature of refrigerating chamber, and then each time a press of temperature Adjusting button of the refrigerating chamber, the temperature will be reduced 1 °C; The temperature setting range for refrigerating chamber is 2-8 °C. Is 2 °C, press the button again, and the temperature of refrigerating chamber will be set at Temperature of freezing chamber and then each time a press of temperature adjusting Button of the freezing chamber, the temperature will be reduced 1 °C; The temperature setting range for freezing chamber is -24 °C ~ -16 °C). When the temperature is -24 °C, press the button again, and the temperature of freezing When super cool mode is set, temperature of refrigerating chamber will automatically set at 2 °C; Super cool exits for 6h. Back to temperature set before super cool mode. Back to temperature set before super freezing mode. Storage upon power failure In case of power failure, the instant working state will be locked and maintained till re-electrification. Fault indication The following warnings appearing on the display indicate corresponding faults of the refrigerator. Though the refrigerator may still have cold storage function with the following faults, the user shall contact a maintenance specialist for maintenance, so as to ensure optimized operation of the appliance. Maintenance and care of the refrigerators overall cleaning · Dusts behind the refrigerator and on the ground shall be timely cleaned to improve the cooling effect and energy saving. Check the door gasket regularly to make sure there are no debris. Clean the door gasket with a soft cloth dampened with soapy water or diluted detergent. The interior of the refrigerator should be cleaned regularly to avoid odor. [. . . ] Check whether accessories are placed at proper locations Door seal fails to be tight Water pan overflows Hot housing Surface condensation Abnormal noise Remove foreign matters on the door seal ?Heat the door seal and then cool it for restoration (or blow it with an electrical drier or use a hot towel for heating) · There is too much food in the chamber or food stored contains too much water, resulting in heavy defrosting. The doors are not closed properly, resulting in frosting due to entry of air and increased water due to defrosting. Heat dissipation of the built-in condenser via the housing, which is normal ? [. . . ]