Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual VARDE IN-LINE. We hope that this VARDE IN-LINE user guide will be useful to you.
Lastmanuals help download the user guide VARDE IN-LINE.
Manual abstract: user guide VARDE IN-LINEMONTERING MANUAL
Detailed instructions for use are in the User's Guide.
[. . . ] This will ensure that your particular fireplace insert is correctly fitted. There may be special conditions which require deviations from the fitting instructions, such as the type of flue that should be used. You are required to notify your local chimney sweep if a fireplace insert has been fitted. [. . . ] The location of the access hatch can be a major help when you later install the flexible tubing. Other regulations for the installation of access hatches must always be observed. Once the tubing is secured in the chimney, the accompanying 45° flue should be attached to the other end of the tubing. | Remove the vermiculite plates and the base slab from the insert in the order shown. Before replacing the vermiculite plates and the base slab, adjust the fireplace insert until it is straight and flush with the front of the fireplace. | Adjust the four screws in the bottom of the insert , as shown. | A spirit level may be used to ensure that the insert is level. | You can also fasten the insert to the bottom of the fireplace with a couple of frame screws, concrete screws or the like, via the two large holes in the base. | Pull the flue in through the rear opening in the fireplace insert. The fireplace insert must be reassembled before it is ready for use. | Replace the vermiculite plates and the base slab in the insert , in the order shown. | Fill in the top 2-3 cm with fireplace mortar to fix the tubing in place. Your fireplace insert is now ready for use. All local regulations, including those that refer to national and European standards, must be complied with during fitting, e. The Danish building regulations for small houses, BR-S 98, published by the National Agency for Enterprise and Construction. If there is a floor made of combustible material by the fireplace insert, this must naturally be covered by a panel of non-combustible material such as a steel plate, glass sheet, Dutch brick or artificial slate. [. . . ] | When stoking, it is recommended that the door is not opened to insert more wood until only a few embers remain in the firebox. The presence of flames means that smoke and gases are still being produced, and there is thereby a risk of smoke downdraught. | The air supply can be adjusted while the fire is burning using the air inlet, as shown. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE VARDE IN-LINE
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual VARDE IN-LINE will begin.
