User manual VDO DAYTON CHM 604 MP3

[. . . ] · Do not attempt to repair or service the CD changer yourself. Return the unit, plus cartridge with the transport screws in place, to your dealer or an authorised Service Agency (see addresses at the end of this booklet). · Temperatures inside the parked car will fluctuate considerably during summer and winter. They should not exceed +70°C or ­20°C when operating the CD changer. · To avoid too high temperature, never install the changer on top of the dashboard or on the rear parcel shelf. [. . . ] Fix the base plate X2 to the chassis using tapping screw E. The base plate must be fixed to a flat surface. If there is no flat surface in the luggage boot, a wooden mounting board (approx. 10 mm thick) under the carpet should be used instead of the base plates. (Fix the wooden mounting board to the car using three screws). In that case fix the brackets to the board (laying under the carpet) using screws. 1 2 3 4 Remove the nuts D. Lay the carpet over the base-plates (or the wooden mounting board) and cut four smallcrosses in the carpet. Check that the three transport screws have been removed from the underside of the CD changer!Mount the CD changer using the nuts D (Fig. 12). The CD changer can also be mounted on the underside of a flat surface, e. g. 1 Fix bracket A to the sides of the CD changer using the washer screw C(Fig. 13). 2 Place the CD changer in the mounting position (Fig. 14). 3 Mark positions for four mounting holes (with a felt-tip pen). 4 Drill holes of 3. 6 mm diameter in the marked positions. 5 Check that the three transport screws have been removed from the underside of the CD changer!6 Hold the CD changer in place and attach it with the tapping screws E MOUNTING IN SUSPENDED POSITION 5 CDC603A Aug. 06-03 MOUNTING CONNECTING THE CABLES (Fig. 15) Only use the cables supplied to connect the CD changer to the car radio! 1 2 3 4 5 Ensure that the negative car battery terminal is disconnected. Connect the car radio as described in the car radio's mounting instructions. Connect the blue plug C3 of the extension cable to the rear of the car radio (socket C3') (fig. 15). If your car radio does not already have a socket for the suitable connector, consultyour dealer for an adapter cable. Connect the extension cable to the fly lead cable of the CD changer. Reconnect the negative car battery terminal. Installation is now complete. 6 CDC603A Aug. 06-03 OPERATION FILLING THE CARTRIDGE 1 2 GB Pull the tab on the cartridge's disc tray to remove one of the trays. 3 Place the disc on the tray with the label side up Each tray can accommodate only one disc. The CD changer will not function if the discs are placed upside down. Press the tab on the disc tray to store the tray back in the cartridge. INSERTING THE CARTRIDGE 1 2 Open the sliding door. 3 4 Hold the cartridge the correct way up with the narrow side facing the opening of the CD changer as shown. [. . . ] Remove screws (x3) on bottom of unit and then use. Adjust setting mechanisms in proper direction (refer to "Installation" in Operating Instructions). Direction in which it is inserted is wrong. Noise is heard during playback or sound is intermittent. Extremely dirty disc. Setting mechanisms of shock absorbers are adjusted in the wrong direction. CD player does not function. If the weather is cold there Wait for about 5 minutes for may be some condensation the moisture to evaporate. [. . . ]