User manual VDO DAYTON CI 3000

[. . . ] increased risk of injury in the event of an accident. Do not install components in the inflation range of the airbag or in areas where the head or knees may knock against them. Only install in vehicles with 12V on-board voltage and negative earth. [. . . ] Before starting work, disconnect the earth lead from the negative terminal of the vehicle battery in order to prevent short circuits. At the same time, follow the vehicle manufacturer's safety instructions (alarm system, airbag, immobiliser, radio coding etc. The CI 3000 must on no account be installed in the following locations: Near electric motors or other vehicle electrical system assemblies. In some exceptional cases, the hands-free unit can also be connected to the serial port of the CI 3000. Information regarding compatible hands-free units and mobile phones can be obtained from our website, www. S Navigation computer (PC 54XX, PC 54XXpro, PC 55XX and PC 55XXpro) Plug the blue C3 power supply lead connector of the CI 3000 in the C3' socket of the navigation computer. The CI 3000 can be connected to an MC 5400 Multimedia Centre (accessory) using adapter lead CA 3050. The MC 5400 must be set to "CI 3000" in the "Internet Access ­> Settings ­> Mobile" menu in order to ensure proper functioning. Connection to the MC 5400 is not possible in conjunction with CIX 3000 Blue. For direct connection of permanent positive (red wire) to the battery, the fuse must be no further than 10 - 15 cm from the positive terminal of the battery. If it is necessary to extend the positive lead, an additional 10 A fuse must be provided close to the battery (max. This connection should be rated for a current of at least 2 amps. Two basic concepts are shown in Figures 5 and 6. For the connection configuration suitable for your hands-free unit, please consult your VDO Dayton dealer. For connection details, refer to the instructions supplied with the specific connection lead required. Connection leads are available as original VDO Dayton accessories for most common handsfree units. [. . . ] Connection of components (MC 5400 or hands-free unit) to the serial port of the CI 3000pro is not possible as this port is deactivated. If you have not yet done so, load the current , system software version on your navigation system. Make a test call in order to check operation of the CI 3000. [. . . ]