User manual VDO DAYTON MM 2100

[. . . ] The following reading aids are used to simplify these operating instructions:  asks you to perform an action. Safety instructions and warnings contain important information for the safe use of the unit. Failure to observe this information may result in a risk of damage or injury. Therefore, please observe this information with particular care. A Safety instructions For safety reasons, the driver should not watch TV/DVD or similar when driving. [. . . ]  In order to display the navigation image, switch the MM 2100 on again via the on/off button. Volume setting    Turn the volume control 3 during a guidance information message in order to set the desired volume of the built-in loudspeaker. Ensure that the navigation system volume is set to a medium level (see navigation system operating instructions). Turn the brightness control 1 in order to set the desired monitor brightness. Brightness setting 4 INSTALLATION INSTRUCTIONS IMPORTANT INFORMATION A A A A A A Only trained specialists may install the unit. Observe automotive industry quality standards and the relevant local statutory regulations. It is essential to observe the following when installing components in the passenger compartment: Ensure that the driver has a clear all-round view. Increased risk of injury in the event of an accident. Do not install components in the inflation range of the airbag or in areas where the head may knock against them. Only install in vehicles with 12V on-board voltage and negative earth. Risk of malfunction, damage and vehicle fire if installed in unsuitable vehicles (e. In order to ensure perfect installation, use only the original components supplied. The use of non-authorised components may result in malfunction. Scope of delivery Check the scope of delivery for completeness before starting work. The complete installation kit contains: 1 MM 2100 with 7 m connecting cable 3 Sets of fastening elements 1 Installation and operating instructions Report faulty components to the Service department and notify any damage to the deliverer (forwarder, package service, post office). Technical data, design and scope of delivery may vary slightly due to product updating. Installation Mounting, Figs. Feed the two long mounting bands with the finely ribbed side facing inwards into the slots provided at the top of the mirror back (Fig 1). Push the two fasteners with the large ribs facing outwards into the slots provided at the bottom of the mirror back (Fig. Attach one of the mounting bands to the corresponding fastener, leaving sufficient slack for mounting onto the vehicle mirror. Now slide the MM 2100 sideways over the vehicle rear view mirror. Pull the already attached mounting band tight so that the MM 2100 is held firmly in place. 1 2 5 English INSTALLATION INSTRUCTIONS 5. Then attach the other mounting band to the corresponding fastener behind the vehicle rear view mirror. Bring the MM 2100 into the final installation position and pull the mounting bands tight in order to ensure that it is firmly attached (Fig. To release the mirror, press the sides of the fastener together (e. g. for subse3 quent adjustment or to remove the mirror). [. . . ] · Set the desired volume at the mirror. · Switching off the monitor via the on/off button. · Point the remote control at the infrared receiver 5 of the MM 2100 to operate the navigation system. The battery symbol flashes in the navigation system status line: · Replace the batteries of the remote control. The picture is excessively dark/bright. [. . . ]