User manual VDO DAYTON PN 4000 TSN QUICK START GUIDE

[. . . ] All changes to the GPS availability and accuracy, as well as other factors from the surrounding environment can influence the operation of the navigation system. The supplier of this system does not accept any liability whatsoever for the availability and accuracy of GPS data. WEEE compliance All electrical and electronic equipment must be disposed of separately from general household waste using the sites designated by local authorities. If a product displays this symbol of a crossed-out rubbish bin, the product is subject to European Directive 2002/96/EC. [. . . ] Nor should the device be attached within the area in which the airbags open or within reach of the head or knees in the event of a collision. Secure the device so that it will not slide around in the event of emergency braking or a collision. · 12 PN 4000/6000 To install the device in the vehicle, proceed as follows: · Find a suitable place in the vehicle for attaching the cradle. The screen should be clearly visible from the driver's seat but the device should not obscure the driver's view. · Press the suction cup against the glass (with a clear view of the sky) and move the pressure lever towards the glass until it locks in place. · Attach the navigation system to the cradle. Detaching: To detach the device, move the pressure lever to the opposite direction and carefully pull the transparent rubber end of the suction cup to remove it from the windscreen. For safety reasons you should install the device and enter the required information in the system before you start your journey or when your vehicle is stationary. The use of the navigation system does not under any circumstances release the driver from their personal responsibility. The applicable road traffic regulations and current traffic conditions always have priority. The information provided by the device is for orientation purposes only and is not binding. Always check the information provided by the device (speed, remaining travelling time, distance, recommended route). Only look at the screen when it is safe to do so. If you need to look at the screen for a longer period of time, stop the vehicle at an appropriate and safe place. The touchscreen must not be operated with sharp or rough-edged objects as these can damage it. If you leave the vehicle for long periods you should take the navigation system with you to avoid theft. GPS reception When you switch on the device for the first time, it can take several minutes for the GPS reception to reach a sufficient level and to determine your current position. Always hold the navigation system vertically. If you are using the navigation system in an inner-city area, it may take longer to refresh the map details. PN 4000/6000 Navigation · · · After switching on the navigation system, the legal disclaimer screen appears. As soon as the system is ready, the Main menu will appear on the screen. 13 Main menu Tap on Settings > Regional. · · · · · · Language: select your preferred language for the menu and map display. Voice: select the preferred voice for the navigational information. House number position: in the first or last place. Time format: switch between 12h/24h time format. [. . . ] To switch on the television, tap the DVBT button in the Multimedia menu. The television screen will be displayed with the buttons for operating the television receiver. Scanning for and selecting a channel Call up the scanning and channel selection functions by tapping the Channels bar at the top of the screen. Tap the Channels bar to open the relevant submenu. Tap the Scanning Channels button to start scanning. Once the search has ended the list of channels found will be displayed. Tap the required channel to view the current programme. [. . . ]