User manual VDO DAYTON MS 4200

[. . . ] 80 Address book – Selecting an address . 81 Geographical coordinates destination . 82 POI – "Point of Interest" destination . 103 54 General advice Safety advice and important information Before you start to install and use this navigation system, please familiarise yourself with its various components and functions. [. . . ] Security code settings: Tap this button to protect your navigation system with a password (security code). The following options then allow you to enter a security code or delete the current code. The password is then requested each time the system is restarted. The system cannot be used if the valid password is not entered. The security code may contain letters and/or digits. The maximum length of the security code is 16 digits. You can use this function to protect the personal data (addresses) that is stored on your navigation device. Make a note of the password and store it in a safe place. Use this button to delete a defined password. 76 Bluetooth settings Settings Bluetooth functions such as handsfree calling and pairing can only be used when the navigation system is placed in the MA3000TB Bluetooth cradle. If the navigation system is not placed in the cradle, the Bluetooth functions are not available and the Bluetooth buttons on the screen are deactivated. The Bluetooth settings can also be called up from the Main menu via the Multimedia button. Before the list is deleted a confirmation screen appears. 78 Settings Toolbar The toolbar provides a shortcut to different functions and information (e. g. mute, volume setting, day/night mode, route changes and information). You can open and close the toolbar by tapping the logo in the bottom right of the screen. The toolbar can be opened on any screen. This fast access is particularly useful during guidance. Toolbar functions The Information function, with the TMC-based traffic information display options is opened directly. The Map display > Display settings submenu with the guidance display settings is opened directly. See "Display settings" on page 65. The Change route function, with detour options for traffic jams is opened directly. This also offers direct access to the Recalculate route function. See "Change route – avoid traffic jams" on page 72. The Set route profile function with route profile settings and route planning options is opened directly. [. . . ] If the TMC is switched off, a red cross is displayed instead of a tick or a provider. If the TMC is switched on and you are receiving travel information, expected delays are displayed in the status bar (e. g. The delay is indicated by the colour of the hourglass: Red TMC reception OK; delay on selected route Green TMC reception OK; no delays Grey TMC unavailable or switched off If the TMC is switched on and there is a traffic jam on your route, a corresponding icon appears on the left in the map display screen. Tap this icon and a list of detailed information appears. 102 Troubleshooting Solution The GPS signal can be blocked by heated windscreens or tinted windscreens with a vacuummetallised coating. [. . . ]