User manual VERBATIM EXTERNAL HARD DRIVE USB 2.0

[. . . ] Automatic power sleep function to extend battery life 4. Rechargeable batteries can be recharged by connecting the mouse to the computer USB port using the supplied USB cable System Compatibility Win 95/98/Me/2000/XP Macintosh 9. x, 10. x Initial Set up 1. Turn the computer power on and log in 2. [. . . ] Turn the computer power on and log in 2. Connect wireless mouse receiver to USB port 3. Ensure batteries are installed in the mouse and mouse power is turned on (See instructions below). Click the ID button at the end of the receiver once, (See Figure 1 below). Next, click the ID button on the underside of the mouse as indicated in Figure 1 Figure 1 7. The red light on the receiver will flash rapidly for a few seconds then stop flashing 8. Now the mouse is ready for use Battery Installation 1. To turn the mouse power off click on the ID button on the underside of the mouse for over 3 seconds until the light turns off 4. Optical mouse will not operate correctly on any reflecting surface such as glass or 3D mouse pads Caution Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: * * * * Reorient or relocate the receiving antenna. [. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: * * * * Reorient or relocate the receiving antenna. [. . . ]