User manual VESTAX MX-1

[. . . ] Handle only the plug or connector and do not perfrom these operations wiht wet hands. Keep away from liquids Do not stand cans contaning lipuids on or near the equipment. If liquid enters equipment, disconnect the power cord from the power outlet immediatcly. WARRANTY The warranty might vary from country to country. Each distributor has their own warranty system in accordance with the country or state regulations or laws. [. . . ] The product does not appear to operate normally or level that is uncomfortable. exhibits a marked change in perfromance ; or 5. The product should be location or position dose not interfere E. The product has been dropped, or the enclosure damaged. Do not attempt to service the product beyond that described in with its proper ventilation. The product should be located away from heat sources such as the use - maintenance instructions. All other servicing should be referred to qualified service personnel. radiators, heat registers, or other products that produce heat. The product should be connected to a power supply only of the type described in operating instructions or as marked on the product. TOP PANEL PROGRAM INPUT SECTION PRO FESSIONAL MIXING CONTROLLER LINE 4 IN L R INPUT PHONO 1 PGM 1 INPUT LINE 2 PHONO 2 SUB INPUT LINE 4 PHONO 3 PGM 2 LINE 6 MASTER +8 +5 +3 +8 +5 +3 +1 0 -1 -3 -5 -7 -10 -15 POWER CUE MIC TRIM LINE 1 LINE 3 LINE 5 MASTER SECTION +1 0 TRIM TRIM -1 -3 MIC-1 MIC-1 MIC-2 MIN MAX MIN MAX MIN MAX -5 -7 -10 -15 BAL BAL BAL MICROPHONE SUB INPUT SECTION MIN MAX L R L R L R POWER MIC-2 EQ HI EQ HI EQ HI L R EFFECT SEND MIN MAX EQ HI -16dB +16dB -16dB +16dB -16dB +16dB MID MID MID MIN MAX RETURN -16dB +16dB -12dB +12dB -12dB +12dB -12dB +12dB LOW LOW LOW LOW MIN MAX CUE -16dB +16dB -16dB +16dB -16dB +16dB -16dB +16dB EFFECT OFF POST EFFECT PRE OFF POST EFFECT PRE OFF POST EFFECT PRE OFF POST OFF ON MASTER BAL CUE OFF ON CUE OFF SIGNAL ON CUE OFF SIGNAL ON CUE OFF SIGNAL ON L R LEVEL 10 9 8 7 6 5 4 3 2 1 0 10 9 8 7 6 5 4 3 2 1 0 10 9 8 7 6 5 4 3 2 1 0 MIN MAX MONITOR SPLIT CUE ON OFF PHONES LEVEL MIN MAX PHONES IN PGM1 ISOLATOR PGM2 ISOLATOR LOW MID HI 1 2 LOW MID HI ISOLATOR SECTION PHONES IN PROGRAM INPUT SECTION PGM 1 INPUT PHONO 1 PROGRAM INPUT SECTION 1. INPUT SELECTOR Used to select input (2line or 1phono) to be sent to each PGM channel. TRIM CONTROL Adjusts the Input level of each channel. When the cross fader is set in the center, both programs will be heard. This is detachable fader for the ease of replacement witrh CF-R when it is worn out. Remove the multi-cable connecter from fader unit. LINE 2 1 LINE 1 TRIM 2 MIN MAX BAL 3 L R EQ HI -16dB +16dB MID 4 -12dB +12dB LOW -16dB +16dB EFFECT 5 PRE OFF POST CUE 6 OFF SIGNAL ON 10 9 8 7 6 7 5 4 3 2 1 0 Remove four screws. MICROPHONE, SUB INPUT SECTION LINE 4 IN 9 MICROPHONE, SUB INPUT SECTION 9. LINE INPUT JACK(LINE4) Input connectors for line level equipment such as CD players, tape decks , DATs, or MDs ETC. MIC INPUT JACK(MIC1, 2) Input jacks of mic1, mic2. MIC LEVEL Adjusts the input level from all of the microphone inputs. MIC EQUALIZER(HI, LOW) Adjusts the HI and LOW frequencies for all of the microphone input. EFFECT SWITCH MASTER CUE Used when sending signal to the external effect +8 +8 processor connected to the effect SEND/RETURN. CUE SWITCH +3 +3 Used to send the signal from the mic channel to the +1 +1 monitor section for head phone monitoring. 0 0 -1 -1 -3 -5 -7 -10 -15 POWER L R MIC 10 MIC-1 MIC-1 MIC-2 11 MIN MAX MIC-2 MASTER SECTION MIN MAX 16 -3 -5 -7 -10 -15 POWER EQ HI 12 -16dB +16dB LOW -16dB +16dB EFFECT 13 OFF POST CUE 14 OFF ON 15. MASTER OUT LEVEL METER The LED level meters indicate the signal level of the line out. CUE LEVEL METER The LED level meters indicate the signal level of PGM input selected by CUE SWITCH. [. . . ] 27, LOW SWITCH Allows cutting off the sound of the bass range. Sound volume will be cut when the switch is set downward. When the switch is put back, the output volume return to normal. Can be utilized for creating the effects of an acapella. ISOLATOR SECTION PGM1 ISOLATOR LOW MID HI 27 26 25 REAR PANEL 28 30 31 POWER ON OFF AC100V 50 / 60Hz 16W PMC-27 OUTPUT MASTER OUT 1 MADE IN JAPAN SERIAL NO. EFFECT SEND PGM 2 R L R LINE 6 SUB L R PGM 1 LINE 2 L R L R LINE 3 L 34 AC 100V LINE 5 LINE 1 R MASTER OUT 2 L PHONO 3 RETURN GND GND PHONO 2 PHONO 1 33 35 29 32 REAR PANEL 28. [. . . ]