User manual VESTAX PDX-D3S

[. . . ] PROFESSIONAL DIRECT DRIVE TURNTABLE OWNER'S MANUAL VESTAX CORPORATION 2 7 Km m, e gy-u oy 1 4 0 1a a - - a i a t aa , ko 5 - 1 Jpn 31 u Sa kT 0 P o e 3 4 2 0 1 a: 3 4 2 0 3 hn: - 1 - 1 Fx - 1 - 1 03 7 03 7 VESTAX America 2 5 C 9 Ae u . l 3 2 7 0 2 t v Si 1 5 o od 3 0 0 h t e y F P o e 0 - 6 - 2 9 a: 0 - 6 - 1 6 hn: 3 6 6 Fx 3 6 9 375 372 E a et x op r t n mnc m - i s - r oa @ s . 1 s hit p es o d almr, ury U 7 D E g n . 8 t r o hr R a , s ee re G 2 1 Q nl d . s C He S a P o e ) 4 8 5 1 7 a: ) 4 8 6 0 1 h n: 1 2 - 3 1 Fx 1 2 - 1 2 ( 0 6 ( 0 6 CONGRATULATION Thank you for purchasing the Vestax PDX-d3S, Professional Direct Drive Turntable. [. . . ] The pitch speed is controlled by none center click pitch control fader volume. The pitch fader span can be selected between ±12%, ±6%, ±3%. MOTOR OFF function is provided to cancel servo brake of the motor and REVERSE MODE will reverse the turntable thus provided. STICK CONTROLLER is provided for the functions of pitch bend and FAST SLOW, so that it is possible to abjust speed up or down to begin phrase of a song without touching the record. NOTES Before detaching or attaching the headshell, be sure to turn the power of the amplifier or mixer off. Detaching or attaching of the headshell with the volume control turned up may cause damage to the speakers. Do not turn "ON" the power supply, with the turntable platter detached. When play is finished, be sure to secure the tone-arm with the arm clamp. After play is finished, if the unit is not to be used for some time, care should be taken to secure the tone-arm to protect the stylus tip. For the same reason, the stylus protector should also be attached. Wipe the headshell terminals from time to time. Dust and dirt at the headshell terminals may result in increased "HUM" noise or intermittent sound. Use a soft dry cloth to clean the heashell terminals. Dust and dirt should be carefully removed from stylus tip or records. Dust and dirt on the stylus tip or record may not only result in deterioration of tone quality, but also cause undue wear of the record and the stylus tip itself. Transportation of the unit to distant places for removal and the like. Pack up the unit in the reverse order to that for unpacking, using the packing materials furnished when the unit was purchased. Should there be no such packing materials, be sure to take the following steps. Remove the turntable platter together with the turntable mat, and wrap it up to prevent any damage to them. Return the tone-arm to the arm rest, and affix it with tape or the like. Remove the balance weight and the headshell/cartridge from the tone-arm and then wrap them up to avoid and damage to them. Wrap up the turntable base with a blanket or soft paper also to prevent any possible damage to it. ACOUSTIC FEEDBACK AND HUM Acoustic Feedback is usually cause by vibration of speaker, which affects the sensitive cartridge. [. . . ] PITCH BEND RANGE SELECT 3 REVERSE SWITCH Pushing REVERSE SWITCH, the display will indicate "ron" (REVERSE ON), LED above this switch light on. pushing this switch once more , reverse function is canceled and the display indicate "rof"(REVERSE OFF), the LED light off. 4 MOTOR OFF SWITCH Pushing this switch, the motor is disconnected from the servo drive and the turntable turns to until it stops naturally, and itis possible to change rotation motion of turntable by touching the side of turntable. The display will indicate "Sof" (SERVO OFF). [. . . ]