User manual VESTAX PMC-06PRO A

[. . . ] This product should never be placed near or over a radiator or heat register. This product should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer's instructions have been adhered to. Power sources-This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your appliance dealer or local power company. 11. [. . . ] Replacement Parts-When replacement parts are 18. Carts and Stands-The appliance should be used required, be sure the service technician has used only with a cart stand that is recommended by replacement parts specified by the manufacturer manufacturer. or have the same characterristics as the original parts. Unauthorized substitutions may result in 19. An appliance and cart combination should be fire, electric shock or other hazards. Quick stops, excessive force, and uneven surfaces may cause the appliance 17. Safety Check-Upon completion of any service or and cart combination to overturn. repairs to product, ask the service technician to perfrom sefety checks to determine that the product is in proper operating condition. NEW FEATURES & FEATURES THAT VESTAX MADE STANDARD NEW FEATURES THAT VESTAX MADE STANDARD Effects routing. 1 x Effects Send and 1 x Effects Double Panel. Vestax invented the double panel Receive means that you can hook up an external system in order to open up the faceplate for fast effects unit for use during play. The volume of moves and reduce personal injury (fingernails). set, PGM1 will be heard with the crossfader set to the left iMASTER LEVEL VOLUME side. PGM2 will be heard with the cross fader set to the Adjusts the signal level outputs from LINE OUT. When the crossfader is set in the center, both programs will be heard. This is user replaceable fader oCROSSFADER CURVE Replace with a "CF-PCV" when it is worn out. A clockwise rotation gives a steep crossfader good for scratching and !5 EFFECT RCV LEVEL cutting, whereas, a counter clockwise rotation gives a Adjusts the signal level input from an external effects unit gentle crossfader good for long running mixes. connected to the EFFECT RCV jacks on the front panel. !0 POWER LED Lights up when the POWER SWITCH is on. !6 EFFECT SEND LEVEL Adjusts the signal level output to an external effects unit connected to the EFFECT SEND JACK on the rear panel. !1 INPUT SELECTOR !2 INPUT FADER (PGM1/PGM2) Used to select the input (LINE or PHONO) to be sent to each PGM channel. The upper most position will select PHONO input. !7 EFFECT SEND ON/OFF SWITCH This selector switch can also be used to perform for This switch is used to select the PGM to be sent to TRANSFORMER SCRATCH. The operation direction of this EFFECT SEND JACK. To change the operational direction of this !8 MONITOR LEVEL switch remove the top panel and make the necessary the top panel. Adjusts the headphone monitor level. Used to adjust the input level of each PGM channel. [. . . ] These jacks are used to connect turntables equipped with moving magnet (MM) type cartridges. Once #1 POWER SWITCH Use to turn power on. HOW TO CHANGE THE FADER UNIT q Remove the fader knobs. (See fig-a) w Remove the 4 screws which fix the top panel. (See fig-a) e Remove the 2 screws which fix the fader panel, and remove the fader unit from position in mixer. [. . . ]