User manual VEXILAR ULTRA PACK GETTING STARTED

[. . . ] Be sure you read through both sides of this sheet as well as the Owner's Manual for your flasher. Stopper The Ice-Ducer is designed to hold your transducer level at the desired depth below the water surface. Just slide the stopper along the cable (stick your finger in the slot to make it slip easier) and set the distance between it and the bottom of the transducer to the approximate thickness of the ice. Cable storage is located behind the tackle box holder. After you've set the Ice-Ducer depth, wrap the extra cable around the holder arms and then use the cable grips on each side to keep the cable in place. Float The rod holder fits in any of the four sockets located at each corner of the Ultra Pack. [. . . ] In order to insure maximum running time for your flasher and maximum battery life, you need to follow some simple charging rules. The included charger is specifically designed for this battery. The charger is also protected internally from reverse hook up and short circuits. As long as you follow these instructions, you can expect many hours of use and many years of service from the battery. To Charge the Battery 1. Turn the Ultra Pack's Master Power Switch ON. You DO NOT need to disconnect the flasher. Plug the charger into a standard 110 VAC wall outlet. Make sure the charger's light is on. Connect the red charger clip to the positive power post and the black clip to the negative power post. The charger's light should turn off. This indicates that the battery is now accepting a charge. Let the battery charge until the charger's light comes back on. Make sure you wait until it gets to full brightness. Charge times can range up to 48 hours for a completely dead battery. Do not leave the charger connected to the battery for more than 48 hours after the light has come on to full brightness. Tip - For faster charges with automatic shutoff, see your dealer about the optional V-300 1-Amp Automatic Charger. Fully recharge the battery after each use. Be sure to charge it soon after you are done using it. However, do not charge it when it is cold. Bring the battery indoors and allow it to warm up for at least one hour before connecting the charger. [. . . ] Remember, the charger's indicator light is your primary indicator. Use this light to tell you when your battery is fully charged. If you should ever charge your battery without a Vexilar charger, then use the Battery Status Indicator's light as your "charge complete" indicator. Please note that the percent of charge shown will vary with the temperature and battery load. [. . . ]