User manual VIETA IP10B DATASHEET

[. . . ] Connect AC power supply with this product. (Caution: Power source must be consistent with this product. ) 3. Press on the POWER switch button on the Rear Panel of the main unit to switch on the system, the standby indicator will light up. Then press the STANDBY button on the remote controller to enter The normal status. [. . . ] Press the button on the remote controller once again to keep power in standby status. Press the VOL+ turn-knob on the front panel of the main Unit or VOL + button on the remote controller to maximize the sound output. Press the VOL- turn-knob on the front panel of the main unit or VOL - button on the remote controller to minimize the sound output. Press the MUTE button on the remote controller once to keep the performance silent. RESET Press the RESET button on the remote controller and it will reset all settings including SW Speaker output, Front Speaker output , CENTER Speaker output, Surround Speaker output to Factory Default settings. Caution: Please read carefully all the following important safeguards to ensure safe operation. Read Instructions - All the safety and operating instructions should be read before the appliance is operated. Retain Instructions - The safety and operating instructions should be retained for future reference. Follow Instructions - All operating instructions should be followed. Heed Warnings - All warnings on the appliance and in the operating instructions should be adhered to. Power Source - The appliance should be connected to a power supply only of the type specified in the operating instructions or as marked on the appliance. Insert the batteries Insert two 1. 5V size AAA batteries into the compartment of the remote control. Make sure the polarity of the battery must be complying with which on the compartment. Notice: Do not use old battery together with new one. Do not throw the remote control down on the ground or tread on it. Please put out the batteries from the compartment when you do not use it for long extent of time. Effective scope of the remote control The remote control is effective in a scope, which is less than 7 meters, and in an angel of 30 degrees from the remote control to the receiver in the center speaker. Notice: Do not put the remote control and the signal receiver under strong light. Do not place any barrier between the remote control and the receiver. Do not use this remote control at the same time when using any other one. 3 8 REMOTE CONTROL FRONT PANEL - CONTROLS AND FUNCTIONS 1 2 3 4 5 6 11 12 13 14 15 7 8 9 10 16 17 1 2 34 5 6 7 8 9 10 11 1. STANDBY: Power Standby Button. 5. TREBLE-: Treble Downward Adjustment Button. 6. BASS-: Bass Downward Adjustment Button. [. . . ] 5. TREBLE-: Treble Downward Adjustment Button. 6. BASS-: Bass Downward Adjustment Button. 7. VOL-: Volume Downward Adjustment Button. 8. VOL-: Volume Downward Adjustment Button. [. . . ]