User manual VIETA IP2R DATASHEET

[. . . ] REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. IMPORTANT SAFETY INSTRUCTION 1) 2) 3) 4) 5) 6) 7) 8) 9) Read these instructions. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or otherapparatus(including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. [. . . ] Dolby Digital satisfies these needs through the dynamic range controlling. Selects the dynamic range compression to fit the individual listening situation of the audience. The variable range is from FULL, 7/8 to 1/8, or OFF. The default setting is OFF. MAIN PAGE AUDIO RELATED · · · · · FULL: Audio with fully compressed dynamic range. 7/8~1/8: Audio with partially compressed dynamic range. OFF: Audio with uncompressed dynamic range. The default setting is SPDIF/ PCM · Notes The Dual Mono and Dynamic Range settings only support Dolby Digital programs. The higher the setting selected will result in audio with a more fully compressed dynamic range. · · SPDIF/ RAW If the optical or coaxial output on the rear panel is connected with a receiver built-in Dolby Digital, DTS or MPEG decoder, select this item. SPDIF/ PCM If the optical or coaxial output is connected with a receiver which accepts PCM audio signal, select this item. ANALOG If the optical or coaxial output is connected with any equipment, select this item. Preferences setup · You can access PREFERENCES PAGE only in STOP status. Selecting the audio language Select a desired audio language for a DVD disc that has audio data recorded in multiple-languages. -- PREFERENCES PAGE -AUDIO DISC MENU PARENTAL PASSWORD DEFAULTS ENGLISH FRENCH GERMAN ITALISH SPANISH Notes · If the ANALOG is selected, the optical or coaxial will not have audio outputs. · If the DIGITAL/RAW is selected and the audio source is LPCM (DVD), the outputs in the optical or coaxial is PCM. · If the DIGITAL/PCM is selected and the audio source is audio CD, the outputs in the optical or coaxial is PCM. MAIN PAGE PREFERRED AUDIO LANGUAGE The default setting is ENGLISH. Note · · When you select a preferred language that is not recorderd on the DVD, one of the recorded language is automatically selected. Turn your television set' s power on, and set the channel to the video input. Press POWER on the front panel to turn on the main power of this system. The front panel display lights up, and the DVD logo screen appears on the television screen. Press OPEN/CLOSE, and place a disc on the disc tray. Note · Load the disc placing the label side face up, and using the disc tray as a guide for proper alignment. When playing a double-sided DVD disc, load it with the desired playing side face down. Use the master VOLUME (+/-) buttons to increase or decrease the volume level. To start playback, press back, press /ll again. To interrupt or pause play2 Basic playback For VCD / CD discs FF(fast forward) : FFX1 --> FFX2 --> FFX3 --> FFX4 --> PLAY FR(fast reverse) : FRX1 --> FRX2 --> FRX3 -->FRX4->PALY To resume normal play, press PLAY/PAUSE /ll. . Slow motion playback To view playback in slow-motion, press SLOW on the remote control unit during playback. When playing DVD discs: Press SLOW repeatedly to select the slow motion speed and direction as follows: SF ( slow forward) , SR (slow reverse) . SFX4 SFX8 SRX2 SRX4 SFX2 SLOW OFF. SRX8 When playing CVD, SVCD or VCD discs: Press SLOW repeatedly to select the slow motion speed as follows: SFX2 SFX3 SLOW OFF. [. . . ] · The aspect rate is fixed on your DVD disc. · If you connect the system with the S-Video cable, connect directly to the TV. Otherwise, you may not change the · · · · · · aspect rate. Depending on the TV, you may not change the aspect rate. Severe hum or noise is heard Check that the speakers and components are connected securely. [. . . ]