User manual VIEWSONIC PJ862

[. . . ] ViewSonic PJ862 Portable LCD Projector ® User Guide Guide de l'utilisateur Bedienungsanleitung Guía del usuario Guida dell'utente Guia do usuário Användarhandbok Käyttöopas Compliance Information For U. S. A. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Performing the LOAD1, LOAD2, LOAD3 or LOAD4 loads the data on the memory whose number corresponds with the command's number, and adjusts the picture automatically depending on the data. Performing the SAVE1, SAVE2, SAVE3 or SAVE4 puts the current adjustment data on the memory whose number corresponds with the command's number. · Current adjustment data of the items in the PICTURE menu is stored. · Although adjustment data under the CUSTOM in the items of GAMMA and COLOR TEMP is not stored, it is memorized that the CUSTOM is selected. MY MEMORY ViewSonic PJ862 28 Multifunctional settings IMAGE Menu With the IMAGE menu, items shown in the table below can be performed. Select an item using the cursor buttons / on the projector or remote control, and press the cursor button on the projector or remote control, or the ENTER button on the remote control to progress. Then perform it referring to the following table. Item Description Using the buttons / switches the mode for aspect ratio. At a RGB/DVI signal 4:3 16:9 NORMAL At a video signal / no signal 4:3 16:9 SMALL · The NORMAL mode keeps the original aspect ratio of the signal. · At a HDTV signal of 1125i (1080i) or 750p (720p) of COMPONENT VIDEO input, this item can't be selected. · Performing the automatic adjustment initializes the aspect ratio setting. Using the buttons / adjusts the over-scan ratio. Large (It reduces picture) Small (It magnifies picture) · This item can be selected only at a video signal. · When this adjustment is too large, certain degradation may appear at the frame area of the picture. Using the buttons / adjusts the vertical position. Up Down This item is not selected when DVI-D input port is selected. Using the buttons / adjusts the horizontal position. Left Right This item is not selected when DVI-D input port is selected. Using the buttons / adjusts the horizontal phase to eliminate flicker. Right Left · This item can be selected only at a RGB signal or a component video signal. Note that this does not work with the input signal of 525i(480i)/625i(576i) from the component video port. MENU[RGB] :SELECT PICTURE ASPECT4:3 IMAGE OVERSCAN95 VIDEOQlty. VPOSITION25 INPUT HPOSITION142 SETUP HPHASE16 SCREEN HSIZE1344 OPTION AUTOADJUSTEXECUTE NETWORK EASYMENU ASPECT OVER SCAN V POSITION H POSITION H PHASE ViewSonic PJ862 29 Multifunctional settings IMAGE Menu (continued) Item Description Using the buttons / adjusts the horizontal size. Large Small · This item can be selected only at a RGB signal (except DVI-D). · When this adjustment is excessive, the picture may not be displayed correctly. [. . . ] Poland: Two (2) years warranty for all parts excluding the lamp, two (2) years for labor, and ninety (90) days for the original lamp from the date of the first consumer purchase. Other regions or countries: Please check with your local dealer or local ViewSonic office for the warranty information. Lamp warranty subject to terms and conditions, verification and approval. Applies to manufacturer's installed lamp only. [. . . ]