User manual VIEWSONIC PJD5111

[. . . ] ViewSonic PJD5111 DLP Projector ® - User Guide - Guide de l'utilisateur - Bedienungsanleitung - Guía del usuario - Guida dell'utente - Guia do usuário - Användarhandbok - Käyttöopas IMPORTANT: Please read this User Guide to obtain important information on installing and using your product in a safe manner, as well as registering your product for future service. Warranty information contained in this User Guide will describe your limited coverage from ViewSonic Corporation, which is also found - using the Regional selection box in the upper right corner of our website. "Antes de operar su equipo lea cuidadosamente las instrucciones en este manual" Model No. : VS12440 Compliance Information FCC Statement This device complies with part 15 of FCC Rules. [. . . ] This function is only available when PC signal (analog RGB) is selected. 24 Operation Fine-tuning the image size and clarity 1. Adjust the projected image to the size that you need using the zoom ring. 2. Then sharpen the image by rotating the focus ring. Correcting keystone Keystoning refers to the situation where the projected image is noticeably wider at either the top or bottom. It occurs when the projector is not perpendicular to the screen. To correct this, besides adjusting the height of the projector, you will need to manually correct it following one of these steps. · Using the remote control Press / on the projector or remote control to display the Keystone correction page. Press to correct keystoning at the top of the image. Press to correct keystoning at the bottom of the image. Press MENU/EXIT and then press / until the DISPLAY menu is highlighted. Press to highlight Keystone and press MODE/ENTER. Press to correct keystoning at the top of the image or press to correct keystoning at the bottom of the image. Press / . Press / . Operation 25 Magnifying and searching for details If you need to find the details on the projected picture, magnify the picture. Use the direction arrow keys for navigating the picture. Press Digital Zoom +/- to display the Zoom bar. Press Digital Zoom + to magnify the center of the picture. Press the key repeatedly until the picture size is suitable for your need. Use the directional arrows ( , , , ) on the projector or remote control to navigate the picture. To restore the picture to its original size, press AUTO. When the key is pressed again, the picture is further reduced until it is restored to the original size. Press MENU/EXIT and then press / until the DISPLAY menu is highlighted. Press to highlight Digital Zoom and press MODE/ENTER. Repeat steps 2-4 in the section of "Using the remote control" above. Or if you are using the projector control panel, continue to the following steps. Press on the projector repeatedly to magnify the picture to a desired size. [. . . ] Take or ship the product in the original container packaging to an authorized ViewSonic service center. Round trip transportation costs for in-warranty products will be paid by ViewSonic. Limitation of implied warranties: There are no warranties, express or implied, which extend beyond the description contained herein including Exclusion of damages: ViewSonic's liability is limited to the cost of repair or replacement of the product. Damage to other property caused by any defects in the product, damages based upon inconvenience, interference with business relationships, or other commercial loss, even if advised of the possibility of such damages. [. . . ]