User manual VIEWSONIC WPG-360

[. . . ] ViewSonic ® - UserGuide - Guidedel'utilisateur - Bedienungsanleitung - Guíadelusuario - Py - () - () WPG-360 WirelessPresentationGateway ModelNo. :VS13670 ComplianceInformation ForU. S. A. This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. [. . . ] For MAC: It requires "Get" and "Set" two steps to make your computer's player for projection. Get: Select "Get" to get a frame on your computer's player. Set: Select "Set" to confirm the frame of the player for projection. Close: To unlock the frame of your player for projection. Select a desired area on your computer's desktop for projection. Select Area When you selected an object or area for projection, click `Play' button to start projection. In this mode, only the object or area you selected will be displayed on projector. 3-6 USB Display The function allows to project your computer's desktop on screen via the connection of Mini USB Type B to USB Type A cable. Once the connection and detection are succeed, a inquiry window will automatically pop up ViewSonic WPG-360 21 to ask you to execute "vsPresenter" to make the desktop of your PC output to the screen. If the inquiry window is not pop up, please access to the disk "vsPresenter" from "COMPUTER" and execute "vsPresenter. exe". NOTE: Only "Play", "Stop", "Pause", "Minimize", and "Close" keys are available during the USB display operation. If the image can not be projected, please disable firewall on your system. USB display will not work when someone is doing the presentation. Please stop the presentation before use. Please do not store any data to the disk of "vsPresenter" under "COMPUTER", or the system will not work properly. USB Display will not work when presentation or broadcast function is operating. Please stop them before use. ViewSonic WPG-360 22 Chapter IV Configure WPG 4-1 Conference Control When there is more than one presentation login to WPG, you can control the content from different presenter via Conference Control webpage. Use the web browser to connect to the IP address of WPG (Wireless / Wired IP address). WPG's IP address can be found at the lower-left corner of Instruction page (refer to chapter 2-1). Click `Conference Control' from WPG's web user interface. All users currently logged in will be displayed here. To select a user's display content in certain area of Quarter-Split Display, click number 1 to 4; to display in full-screen, click button of the presenting user. To stop a progressing presentation, click NOTE: When "Administrator Mode" is enabled, all buttons of the application software will be disabled. ViewSonic WPG-360 23 To select user by remote controller: When there is more than one connected application software, you can also use remote controller to select one of them to display the content (same as `Conference control' function described in last chapter). Press `Login' button on remote control. You can use `Prev. ' and `Next' button on the remote controller to move the bar, then click button to select the presenting user. ViewSonic WPG-360 24 4-2 Connect to Web Configuration Menu Use the web browser to connect to the IP address of WPG (Wireless / Wired IP address). WPG's IP address can be found at the lower-left corner of Instruction page (refer to chapter 2-1). Click `Administrator Login' link on the left. Please input `admin' as username. [. . . ] Check the connection between video display and WPG. Make sure the video display you're using supports the video output mode you selected (in VGA mode). Make sure the video display is switched on. Scenario: I hear noise when WPG is operating. [. . . ]