User manual VIKING RANGE VUC181BK INS

[. . . ] Allow 25" (63. 5 cm) in front of compactor to remove drawer. Six inches of clearance is needed on the right side of the compactor drawer to be able to remove basket/bag. WARNING: FIRE HAZARD Do not let any item fall or collect behind the compactor. FRONT 17 13/16" (45. 2 cm) REAR SIDE 26 1/16" (66. 2 cm) 23 5/8" (60. 0 cm) Min. 35 11/16" (90. 6 cm) 3 1/2" (8. 9 cm) Electric/Cord Data ·2-wire with ground/ 3 prong plug ·bracket to end 54" (137. 2 cm) ·total length 72" (182. 9 cm) ·115 VAC/60 hz ·separate 15 amp min. 24 1/2" (62. 2 cm) 2 7/8" (7. 3 cm) CUTOUT CLEARANCES 1/4" (. 6 cm) Min. [. . . ] A 115 volt, 60 Hz fused electrical supply is required. (Time-delay fuse or circuit breaker is recommended). It is recommended that a separate circuit serving only this appliance be provided. RECOMMENDED GROUNDING METHOD Do Not, under any circumstances, remove the power supply cord grounding prong. For your personal safety, this appliance must be grounded. This appliance is equipped with a power supply cord having a 3-prong grounding plug. To minimize possible shock hazard, the cord must be plugged into a mating 3-prong, grounding type, wall receptacle, grounded in accordance with the National Electrical Code ANSI/NFPA 70 latest edition and all local codes and ordinances. If a mating wall receptacle is not available, it is the personal responsibility and obligation of the customer to have a properly grounded, 3-prong, wall receptacle installed by a qualified electrician. 3-prong grounding-type wall receptacle power supply cord grounding prong 3-prong grounding plug START INSTALLATION Begin with compactor in room where it will be installed. CAUTION: PRODUCT/FLOOR DAMAGE ·Do not grasp the console to move the compactor. ·Before moving compactor across floor, slide compactor onto cardboard or hardboard. Failure to follow these instructions may result in damage to floor covering or product. Remove all protective packaging materials such as tape and shipping pads. Waxy residue from protective shipping material may be removed with a mild solution of liquid household cleanser and water. Check that power supply cord is attached to the cord bracket on the rear of the compactor. Measure the height of the cabinet opening from the underside of the countertop to floor. Subtract 1/4" (. 6 cm) from this measurement. Adjust Cord compactor to this height using pliers to lower the compactor leveling feet away bracket from the compactor. Check that compactor is level from front to back and side to side. Adjust the four leveling feet until compactor is level. Allow at least 1/4" (. 6 cm) clearance between the compactor top and countertop. Read use and care manual to fully understand your new compactor. Keep all literature in a safe place for future reference. WARNING: PERSONAL INJURY HAZARD When moving or lifting the compactor, use a glove to protect and cushion you hand. [. . . ] Remove drawer retaining screws from track assembly on each side of drawer. Carefully remove the drawer from the track assembly. Place drawer on its back on top of two corner posts from carton. With a ruler and a pencil or chalk, draw a line where the toe plate interferes with the floor covering. [. . . ]