User manual VINCENT CD-S5

[. . . ] Dear Customer, we thank you for the confidence you prove in purchasing our product. It will match your high demands towards sound and manufacturing quality. Though it is understandable that you want to plug and play this product instantaneously, we encourage you to read this manual carefully before installation. It will help you in handling and operating this machine in your system and obtaining the best possible performance, even if it was installed by your dealer. [. . . ] This method of passing on the signal via the devices' inputs and outputs and of thereby chaining them is also known as "daisy chaining". Many devices which can be controlled by a switching signal (not preamplifiers or integrated amplifiers), have two terminals which do not differentiate between input and output. In this case either of the two can be selected. Even some devices that transmit the switch signal (preamplifiers and integrated preamplifiers) lack this marking. In this case it may be assumed that they both are signal outputs. "POWER CONTROL" sockets of preamplifiers or integrated amplifiers must not be interconnected!All receiving devices must not be connected to more than one preamplifier or integrated amplifier (directly or indirectly)!If a "POWER CONTROL" cable is connected to the back of the CD-S5 and the 12V switching signal is given, the main amplifier can no longer be switched off with the "POWER" button. If the power control function is not desired, the switch signal cables must therefore be removed!The amplifier is switched on and off using this button at the front panel. When switched off the device is internally not separated from the AC power and reacts to a "POWER CONTROL" (12) switching signal. the appliance can not be switched on/off as long as a cable is connected to one of the jacks "POWER CONTROL". As a precaution, before switching on, the volume setting of your system's preamplifier should be reduced. This function may only be activated with the remote control and only during playback. This control is to allow the adaptation of the player to the system (mainly the amplifier) and it must not be used to change the volume of the CD player in daily use. It is sufficient for almost all amplifiers/receivers/pre stages to put the setting to the maximum and to leave it there. A different value is only used if the CD player is much louder compared with the other sources at the amplifier/receiver or it is distorted (clipping). Hold down the "VOL+" button to raise the output level. The maximum signal level is reached with a setting of 26 and the minimum is at 00. This volume control changes the output level of all analogue outputs to the same extent. In order to decode HDCDs properly, this setting must be set to the maximum "26" when playing a HDCD!This function can only be operated using the associated front panel button. [. . . ] Check all the connections of the amplifiers and whether the loudspeakers are working. The cable connections are not tight, the connectors are dirty or a cable is defective. Use a normal high level input ("CD" or "LINE IN") on these devices. The remote control cannot perform any functions No batteries inserted in the remote control, batteries are not inserted correctly or are depleted. [. . . ]