User manual VISA VE-S60T

[. . . ] Safety measures must be practiced at all times during the installation of this product. Use proper safety gear and tools for the installation procedure to prevent personal injury. Prior to the installation of this product, the installation instructions should be read and completely understood. [. . . ] Mark the right (upper and lower) and the left (upper and lower) positions of the small horizontal slots in the two wall plates. You should mark four positions on each wall bracket. Next, pre-drill a 10mm hole in the wall at each marked location. With the help of an assistant, position the wall plate against the wall and line up the mounting slots with drilled holes. Note: If you install on wood wall, make it sure that all the hole must be on the studs!For each location, insert a lag bolt and washer into the wall. Tighten bolt with an open ended socket wrench by turning clockwise until tight. CAUTION: Do not over-tighten bolts-doing so may cause unnecessary damage to the wall. CAUTION: Do not release the wall plate until it is properly mounted and secured to the wall. NOTE: The concrete anchors must be used for concrete or brick wall. They can be purchased at your local hardware store. If necessary, a hammer can be used to lightly tap each anchor into place so that they are flush with the wall. Once all of the anchors are in place, move the wall plate back into position. Attach the nut onto the threaded shaft that is protruding from the wall. Do not tighten until all nuts are in place. To ensure optimal installation, this kit includes various screws of different diameters and lengths. Place your TV screen down on a soft, flat surface, and locate the threaded mounting points that are located on the back of the display. Determine which screw is the correct length by carefully inserting a straw, or toothpick, and mark how deep the mounting point is. [. . . ] To tilt the mount up, press the right knob as you pull on the lower part, while at the same time pushing on the upper crossbar to tilt the mount to the position you want, then release the knob and push slightly until it locked. To tilt the mount down, press the right knob as you pull on the upper crossbar, while at the same time pushing on the lower crossbar to tilt the mount to the position you want, then release the knob and push slightly until it locked. Once the desired level of tilt is achieved, retighten the mount by turning the tension knobs clockwise. [. . . ]