User manual VISIONEER VISIONAID 96-0200-000

[. . . ] Maintenance Kit for an Auto Document Feeder (ADF) with Flatbed Scanner 1 This Kit Contains 1 Bottle of Streak-Free De-Ionized Cleaning Solution 10 Lint-Free Dry Cleaning Cloths (White) 5 Dry Cleaning Cloths (Blue) 3 Scan Through Staticide Wipes 10 Isopropyl Alcohol Pre-Moistened Cleaning Wipes 2 ADF Pad Assemblies Cleaning Instructions Maintenance Instructions Dry Cleaning Cloth & Cleaning Solution (Flatbed Only) · Spray the flatbed glass with the De-Ionized Cleaning Solution · Wipe the glass clean using a lint-free dry cloth (white) · Clean the ADF scan frame (small strip of glass with a white frame and is the only area where ADF images are captured) · Spray the cleaning solution onto a dry cleaning cloth (blue) to clean the outside of the scanner and the cables Scan-Through Staticide Wipes (ADF Only) · Pre-moistened 8. 5x11 pads; keep sealed until use · Open the package and take out the pre-moistened pad · Unfold the pad and place in the ADF · Scan the pad as you would a regular piece of paper · Take the pad from the output bed and repeat the scan process 4 additional times then delete resulting scan images Pre-Moistened Cleaning Wipes · Use these wipes between Staticide Scan Through cleanings · Open the ADF door and wipe down all plastic surfaces 2 · Wipe and rotate the rollers to ensure the entire surface of each roller is clean, wipe down the ADF pad · DO NOT vigorously rub these across the rollers ADF Pad Assemblies · ADF Pads push the paper against the main pick-up roller and is a user replaceable, consumable part · Each pad can be used for up to 20, 000 3 scans · Open the scanner and remove the ADF Pad by pinching the plastic clips on either side of the metal bar, place a new pad in the scanner, press on the metal bar until it snaps into place Note: The scanner should be powered off for all cleaning methods except for when using the Staticide Pads. 1 2 The contents of this kit should be kept in a clean, dry area and out of the reach of children. Do not attempt to clean the black paper-sensor arm, wipe gently around this area without touching the paper sensor. [. . . ] Clean the Flatbed glass any time lines appear in the scan. How do I know if the scanner requires cleaning? When the scanner is jamming multiple times a day. When the scanner is grabbing multiple pages at one time. When the scanner is squeaking as it feeds the page through. When lines appear in the scanned image. What happens if I don't clean the scanner? Excessive dust on the main pick-up roller will make it appear worn and smooth to the touch, causing the roller to skip across the page instead of grabbing properly. Excessive dust on the rest of feed rollers in the scanner will make a squeaking sound as it feeds the paper through. A worn ADF pad does not push the paper fully against the main pick-up roller causing multiple pages to be fed at one time. The ADF pad can last up to 20, 000 3 scans, however it should be replaced as needed if regular cleaning does not resolve miss-feed issues. When cleaning the scanner, take out the ADF pad and look at it from the side, if the rubber tip of the pad has a noticeable and severe wear pattern, then replace the pad. [. . . ] Do not attempt to clean the black paper-sensor arm, wipe gently around this area without touching the paper sensor. 3 This number varies based on scanner model, paper weight, paper texture, size of scan batches and frequency of scanning. [. . . ]