User manual VISIONEER VRS3 INSTALLATION GUIDE

[. . . ] VirtualReScan® 3. 5 Installation Guide 10300408-000 Revision A Copyright Copyright © 2004 Kofax Image Products. The information contained in this document is the property of Kofax Image Products. Neither receipt nor possession hereof confers or transfers any right to reproduce or disclose any part of the contents hereof, without the prior written consent of Kofax Image Products. No patent liability is assumed, however, with respect to the use of the information contained herein. [. . . ] 5 The VRS installation analyzes your system for the amount of space available on the default drive and lists the Space Required and Space Available values below the destination folder information. Accept the default installation folder, C:\PROGRAM FILES\KOFAX\IMGCTLS, or click Browse to select another destination. The default destination may vary if 16 VRS Installation Guide Installation you previously installed VRS or another Kofax application to another location. Figure 2-8. VirtualReScan Setup ­ Confirm Destination Folder Screen 6 If there is not enough disk space to continue the installation, you will be notified via a message box: There is not enough space to install the option(s). Please free up some disk space or modify your selections. In this situation, click OK to clear the message. Then click Cancel and Exit Setup from the subsequent screens to quit the VRS installation. Once you have created more disk space, restart the VRS installation. ­or­ When installing to a drive other than C:, you can verify disk space on the other drive before proceeding. To check the disk space on an alternate drive: a Click the Disk Space button. b At the screen similar to Figure 2-9, select a drive from the list and click OK. The values for available and required space will be updated on this screen and on the VirtualReScan setup page. c Click OK to return to the installation. VRS Installation Guide 17 Chapter 2 Figure 2-9. Disk Space Settings 7 Click Next to confirm the installation folder. A list of scanners will display. Figure 2-10. VirtualReScan Setup ­ Select Scanner 8 Do one of the following: · Select your scanner from the list and click Next. · Select the option to configure the scanner later if you plan to download a VRS Component Installer for a VRS-certified scanner that does not appear on the list, and then click Next. For more information, refer to VRS Component Installers on page 2. · Select the option to configure the scanner later if you have a non-certified VRS scanner that does not appear on the list. When using a non-certified scanner, you will need to use the Kofax Source Manager from the Windows Control Panel to configure the scanner to work with 18 VRS Installation Guide Installation VRS. For more information, refer to Configuring Non-Certified Scanners on page 31. Note If you are using a Böwe Bell & Howell 8000 B/C scanner, two versions of the scanner will appear on the scanner pick list. "Böwe Bell & Howell 8000 B/C" corresponds to the standard interactive version. [. . . ] This appendix explains the special USB driver installation procedures that apply if you are using VRS with one of the following scanners: · · · · Visioneer 9650 Fujitsu fi-4110CU Fujitsu fi-4120C Fujitsu fi-4220C Installing Visioneer 9650 USB Drivers This section explains the USB driver installation procedure for Visioneer 9650 scanners in a Windows XP environment. To install the Visioneer 9650 USB driver Note Do not connect your scanner until you are prompted to do so. 1 2 3 4 5 6 Place the installation CD included with your scanner in your CD-ROM drive. Right-click on the Windows Start button and select Explore. [. . . ]