User manual VISONIC DISCOVERY PIR MCW INSTALLER GUIDE

[. . . ] Rearm Timer: Rearms the detector 2 minutes after the last alarm. version), 433. 92, 868. 95, 869. 2625 or other frequencies according to local requirements. Transmission Sequence: 3 data bursts at variable intervals within 3 seconds. Encoding: 24-bit ID, over 16 million possible combinations. [. . . ] Loosen the vertical adjustment screw, slide the PCB down and remove it via the "keyhole" (see Figure 4). Attaching the Bracket 2 DE3632 E. Rotate the bracket to the desired position (see Figure 7) but do not yet tighten the screw fully. Note: At power up or reset, the LED flashes for 30 seconds regardless of the jumper position and then enters walk-test mode. After 15 minutes the detector enters normal mode in which the LED functions according to the LED control jumper position. . 3. 8 Vertical Adjustment Figure 7. Wall and Ceiling Positions of Bracket F. Mark the points for drilling through the two mounting holes of the bracket. Attach the bracket to the mounting surface. Tilt down or swivel the detector to face the desired direction. Figure 8 shows the tilt/swivel possibilities. Loosen the vertical adjustment screw and slide the printed circuit board up or down to obtain the desired coverage. When done, tighten the screw well. Figure 10. Tilt/Swivel Limits 3. 9 Walk Testing Upon battery insertion or closing of the cover (which results in closing of the tamper switch) the detector goes into walk-test mode and automatically exits the mode after 15 minutes. Set the motion event counter as required (see Paragraph 3. 6). Adjust the vertical angle as desired (see Paragraph 3. 8). Remount the cover and fasten the case closure screw. This results in the resetting of the detector and the start of walktest mode. Wait until the LED stops flashing (about 30 seconds). Walk-test the entire protected area by walking slowly across the detector's field of view, observing the LED. Pause for 5 seconds after each detection to allow the detector to complete its 3-transmission sequence; the LED will light for about 3 seconds. When the walk-test is completed (after 15 minutes), the detector's setting automatically changes according to the LED control jumper setting. The OFF setting is recommended to prevent unauthorized people from tracing the detector's coverage pattern. If the LED is disabled, you may use the control panel's visual and audible indicators to verify proper function of the detector. [. . . ] (ISRAEL): P. O. B 22020 TEL-AVIV 61220 ISRAEL. PHONE: (972-3) 645-6789, FAX: (972-3) 645-6788 VISONIC INC. (U. S. A. ): 65 WEST DUDLEY TOWN ROAD, BLOOMFIELD CT. (UK): UNIT 6 MADINGLEY COURT CHIPPENHAM DRIVE KINGSTON MILTON KEYNES MK10 0BZ. [. . . ]