User manual VISONIC NEXT-K9 PG2

[. . . ] · Automatic termination of walk-test after 15 minutes. · Microprocessor-controlled temperature compensation. · Sealed chamber protects the optical system. · Front cover and back tamper switches, for improved tamper protection. [. . . ] Here you determine whether an alarm will be activated upon continued motion (low sensitivity) or upon a single alarm event (high sensitivity). or Select between "LED ON" and "LED OFF". Here you determine whether or not the alarm LED indication will be activated. 12. DISARM Activity When exiting "ZONES / DEVICES" menu, the PowerMaster-10 system displays the number of devices that need to be updated, as follows: DEV UPDATING NNN. For detailed instructions on Adding Devices, Deleting Devices, Replacing Devices and Defining Defaults see the PowerMaster-10 Installer Guide. 5. Separate the base from the cover (see Fig. Put back the cover to return the tamper switch to its normal (undisturbed) position, and then secure the front cover to the base with the case closure screw. Walk across the far end of coverage pattern in both directions, The red LED lights each time your motion is detected followed by 3 LED blinks. The following table indicates received signal strength indication. LED response Green LED blinks Orange LED blinks Red LED blinks No blinks Reception Strong Good Poor No communication 2 D-302413 IMPORTANT!Therefore, "poor" signal strength is not acceptable. If you receive a "poor" signal from the detector, re-locate it and retest until a "good" or "strong" signal strength is received. Note: For detailed Diagnostics Test instructions refer to PowerMaster-10 Installer Guide. EVENT 1 2 LED Rx Tx A A. INSTALLATION 6. 1 General Guidance (see Fig. Mount on solid stable surface. 6. 2 Mounting (see Fig. 5) 2 A 3 1 2 3 B 1 4 5 6 4 7 Figure 4. The Next-K9 PG2 detector is immune to 38 kg (85 lb) animals moving on the floor or climbing on furniture as long as the activity takes place below 1 m (3 ft). Above the 1 m (3 ft) height limit, the detector is immune to 19 kg (42 lb) pets, but the pet immunity will decrease as the pet gets closer to the detector. It is therefore recommended to select a mounting location that minimizes potential close proximity of animals. C 1. SPECIAL COMMENTS Even the most sophisticated detectors can sometimes be defeated or may fail to warn due to: DC power failure / improper connection, malicious masking of the lens, tampering with the optical system, decreased sensitivity in ambient temperatures close to that of the human body and unexpected failure of a component part. The above list includes the most common reasons for failure to detect intrusion, but is by no means comprehensive. It is therefore recommended that the detector and the entire alarm system be checked weekly, to ensure proper performance. [. . . ] Any repair and/or replacement shall not extend the original Warranty period. The Manufacturer shall not be responsible for dismantling and/or reinstallation costs. To exercise this Warranty the Product must be returned to the Manufacturer freight pre-paid and insured. TEL: (0870) 7300800 FAX: (0870) 7300801. [. . . ]