User manual VISONIC TOWER 20 AM MCW INSTALLATION

[. . . ] SPECIFICATIONS OPTICAL Black Mirror Max. Coverage: At least 12 meters (40 ft) / 90º Detector Technology: 8 independent quad PIR detectors operating in true Quad configuration. Pet-Immune: Up to 18Kg (40lb. ) ELECTRICAL Input Power: Two 3V CR123A Lithium batteries. Risk of explosion if battery is replaced by an incorrect type. [. . . ] Adjust detector's horizontal and vertical angles (see Fig. 5), according to the surveyed ground surface. The vertical angle indicator position for various installation height and coverage distance combinations is detailed in Table 2 (the information refers to a relatively flat surveyed area. however, in any case the vertical adjustment should be verified by walk-test). Fasten the detector to the bracket (see Fig. Table 2 - Vertical Adjustment Reference Mounting Height 3. 0m / 10 ft 2. 5m / 8 ft 2. 0m / 7 ft 1. 5m / 5 ft Coverage Distance 2m / 6. 7ft 4m / 13ft 6m / 20ft 8m / 26ft 10m / 33 ft12m / 39 ft 4 OFF * Use ON when using "old" PowerMax control panels or when using MCR-308 if you desire masking to pass as a TAMPER event at the control panel. 1 1 2 1 1 2 3 2 2 3 4 2 3 4 5 3 4 5 - 3 4 5 - 3. 2 Battery Insertion 3. 3 Enrolling D-301620 3. 5 Test A. Set the detector in Walk-Test mode, as follows: Open the detector bottom cover (see Fig. 3, steps 1 - 3) and then press and release the tamper switch. The LED will flash for 60 seconds and then the detector will enter into 15 minutes walk-test mode. Note: The detector automatically enters into 15 minutes walk-test mode after battery installation or Tamper switch recovery. Adjust the detector in the horizontal plane to cover the required protected area. (Figure 3) It is recommended to perform the first batteries insertion on a desk. Upon battery insertion, the LED will flash for 60 seconds and then the detector will enter into 15 minutes walk-test mode. Enroll the detectors into the alarm system's memory as described in the alarm system installer guide ­ ENROLLING section. Adjust the vertical adjustment to receive the maximum number of detections when crossing the entire 90° pattern. Verify that each time your motion is detected the LED lights for 2 seconds and the control panel receives the alarm. If required, perform detector's horizontal / vertical readjustments. Instruct the user to perform walk test at least once a week, to verify proper operation of the detector. Place a piece of cardboard on the detector's front side, to deliberately mask the optical window. After 2 minutes, the LED should flash (see Table 3 below) and the alarm control panel should receive the masking alarm. Remove the masking from the detector's front side. The LED should extinguish or flash after about 30 sec (see Table 3). Table 3 - LED operation Event LED Operation First 60 sec after battery fast flashing insertion, or closing the detector cover Test mode (15 min. ) Normal mode (*) Mask detection fast flashing fast flashing 5 sec. ON after PIR detection first detection(**) Notes: * LED ON/OFF control by DIP switch #1 (see par. [. . . ] To exercise this Warranty the Product must be returned to the Manufacturer freight pre-paid and insured. All freight and insurance costs are the responsibility of the Purchaser and are not included in this Warranty. This warranty shall not be modified, varied or extended, and the Manufacturer does not authorize any person to act on its behalf in the modification, variation or extension of this warranty. This warranty shall apply to the Product only. [. . . ]