User manual VITEK VT-710S

[. . . ] The product must not have been tampered with in any way then the guarantee will be considered null and void. Should the serial numbers be tampered with in any way then the guarantee will be considered null and void. This guarantee does not affect your statutory rights. Contact VITEK directly for all servicing. VT-710S VITEK 9970 GLENOAKS BLVD. [. . . ] Use only with cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the Unit, 13. Unplug this unit during lightning storms or when unused for long periods of time. Installation Precautions · Do not install the outdoor unit where it will be exposed to direct sunlight or strong reflected light. Placing the indoor unit in extremely bright locations will also adversely effect the picture quality. · Do not install the outdoor unit where it will be subjected to extremes of dust or moisture. · Be careful to properly connect the all cables. · Secure the unit in an appropriately stable location. · Do not install the outdoor unit where it will be exposed to rain. · Do not install the outdoor unit in a location where the lens filter is likely to get scratched or dusty. · Recommended installation height is approximately 155cm for the indoor monitor and 150cm for the outdoor camera. 14. Do not block any ventilation service personnel, Servicing is required openings. install in accordance with the when the unit has been damaged in instructions. any way, such as power-supply cord or plug is damaged, liquid has been spilled 8. Do not install near any heat source or objects have fallen into the unit, the such as radiators, heat resisters, stoves, unit has been exposed to rain or or other apparatus (including amplifiers) moisture, does not operate normally or that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has to blades with one wider the other. A grounding type plug has to blades and a third grounding plug. The wide blade or the third prong are provided for safety. if the provided plug dose not fit into your into your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] Replace the camera unit into the wall bracket and tighten the camara screw. Replace the screw cover, but do not over-tighten otherwise damage to the plastic casing will occur. 6 3 Included Components Base Unit Installation Indoor Monitor Handset Switch Contrast Volume Speaker Monitor Screen Cable Connections When installing this video intercom system take care to connect the cables as follows: 1. Peel back the grey outer covering of the cable to expose the Red and White wires, strip back the colored plastic by approximately 10mm to exposed wire. Following the wiring diagram below, connect the Red line to the terminal marked 1R; the white line to the terminal marked 2W ; the any color cable of the recommended diameter can be used but make sure the same color is connected to the corresponding terminals on the camera and the monitor. [. . . ]