User manual VITEK VTC-C770DN

[. . . ] 700TVL True Day and Night (ICR) Camera VTC-C770DN VITEK · 1/3" Sony High Density EXVIEW CCD · Sony Effio Digital Signal Processor · 700TVL High Resolution · . 003Lux (F1. 2@50IRE) · Supports C/CS mount DC drive lenses · Supports NTSC & PAL Standards · Adaptive Tone Reproduction · 2DNR - Two Dimensional Motion Adaptive Noise Reduction · Motion Detection · Privacy Mask · On Screen Display (OSD) Menu · 24VAC/12DC Dual Voltage VTC-C770DN WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the unit. This symbol is intended to alert the user to the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to a person. Caution To prevent electric shocks and risk of fire hazards, do NOT use other than specific power source. Warning (NTSC version) -- This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at their expense. Caution -- Any changes or modifications in construction of this device that are not expressly approved by the party responsible for compliance, could void the user's authority to operate the equipment. 1 VTC-C770DN Table of contents 1. [. . . ] To save the changes, move cursor to 'SAVE ALL' and press button before exiting the setup menu. Saves all parameters by pressing 8 8 button. DAY/NIGHT AUTO PICT ADJUST WHITE BAL ATR BACKLIGHT NEXT EXIT SAVE ALL ATW OFF OFF VTC-C770DN 6. 2. 1 MAIN menu-2 MAIN menu-2 NR MOTION DET PRIVACY LANGUAGE Default OFF OFF ENGLISH Descriptions Sets the noise reduction parameters for NR MODE, Y LEVEL and C LEVEL. See '6. 9 NR menu' for details. Sets ON/OFF for enabling/disabling MOTION DET. See '6. 10 MOTION DET menu' for the parameter settings. Sets ON/OFF for enabling/disabling PRIVACY. See '6. 11 PRIVACY menu' for the parameter settings. Selects the language out of 7 languages. Sets ON/OFF for enabling/disabling of ID display. Factory default ID is this version of the camera. User programmed camera ID will be lost and restored with Factory default ID after CAMERA RESET. See '6. 12 ID menu' for editing ID. To save the restored parameters, move cursor to 'SAVE ALL' and press button before exiting the setup menu. Sets AGC to compensate the video level when the scene is dim. Sets the brightness level which starts AGC from x0. 25, x0. 50, x0. 75 and x1. 0 of full video level. If set to x0. 50, the camera will start AGC when the video level goes down to below the 50% level. NOTICE : The setting AUTO IRIS at SHUTTER/AGC>AUTO SETUP>HIGH LUMINANCE MODE will be changed to SHUT+AUTO IRIS if MAIN menu-1>LENS is changed to MANUAL. As a result, the lens iris can NOT be fully opened when MAIN menu-1>LENS>AUTO IRIS> MODE is OPEN. This can be recovered by setting SHUTTER/AGC>AUTO SETUP>HIGH LUMINANCE MODE to AUTO IRIS. HIGH LUMINANCE x0. 50 10 VTC-C770DN 6. 3. 2 SHUTTER/AGC>MANUAL SETUP menu MANUAL SETUP MODE Default SHUT +AGC 1/60 (1/50) Descriptions Compensates the video level by the manual shutter control and AGC. Sets the manual shutter to 1/60(1/50), 1/100(1/120), 1/250, 1/500, 1/1000, 1/2000, 1/4000 or 1/10000. Manual shutter is only useful when luminance is unchanged. Higher gain compensates for a brighter scene, but noise increases. Manual AGC can be set to 6, 12, 18, 24, 30, 36, 42 or 44 8dB. SHUTTER AGC 6. 00 6. 4 LENS menu To enter LENS menu, press button at MAIN menu-1>LENS>AUTO. AUTO IRIS TYPE Default DC Descriptions MUST BE SET TO DC ONLY. This camera does NOT support video type auto iris lens. [. . . ] Transparency rate for the mask can be adjusted. 0. 00 - Mask is fully transparent and not visible. Enables or disables the mosaic effect for the selected mask window at AREA SEL TRANSP 1. 00 MOSAIC OFF 6. 13 LANGUAGE menu Seven languages, ENGLISH , JAPANESE, DEUTCH, FRANCAIS, RUSSIAN, PORTUGUES and ESPANOL, are available with this camera. 6. 14 CAMERA ID menu Up to 40 characters can be input for camera ID. [. . . ]