User manual VITEK VTC-IRV30-2810

[. . . ] · The unit may only be opened by authorized personnel. · Never open the device and expose boards or lens. If repairs are undertaken by unauthorized persons the Warranty will be void. If maintenance or repair is required, please call an authorized service center. [. . . ] Supplied Items 1 x Weatherproof D/N Bullet Camera 3 x Mounting screws 3 x anchors 1 x 2. 5mm L-Wrench 1 x Installation and Operating Instructions 5. External Window Sunshield Lock screw for Sunshield Front cover Body Locking screw for radius Locking screw for Tilt-direction Locking screw for Pan-direction Mounting Base Rubber seal 5-2. Internal Infrared LEDs (X30) Lens Hood Zoom adjustment knob Focus adjustment ring 6 5-3. Iris adjustment and Function switches on the Board. Iris Low Iris High S/W 1 Function ELC Default ELC mode. and operating Back light OFF Linear electronic shutter is Set to OFF for auto iris lens Back light compensation is 2 BLC OFF enabled compensation is automatically. N/A Electronic shutter is fixed to Electronic shutter mode follows 6. Installation · Make sure the power is removed before installation. Procedure of installation 1) Locate at the installation position and drill 3 holes for Mount base on the wall. Use MOUNTING TEMPLATE printed on the bottom of the inner packing material as shown in below drawing. 2) Route the power/ video cable from the camera to the monitor location and power outlet. Care should be taken not to damage, kink or expose the cable to a hazardous environment. 7 black 3) Place camera on a pre-drilled position and fix it by using Mounting screws. 4) Adjust the camera direction as in below steps. Direction I: Adjust the camera direction with screw for Pan-direction. Direction II: Adjust the camera direction with screw for Tilt-direction. Direction III: Adjust the camera direction with screw for radius. 6-2. Setup of ZOOM and FOCUS · Adjust zoom and focus in order. 2) Place the separated Front cover in a safe place away from water & dust. 3) Turn Zoom knob CCW slightly to unlock the knob. 4) Adjust Zoom knob to set the zoom or field of view. (Wide 5) Turn Zoom knob CW slightly to lock the knob. [. . . ] If shades by the sunshield are seen on the image you may reverse the sunshield direction backside to front. 9 black 6-4. Power connector Camera can be operated with either 24VAC or 12VDC. Polarity free connection is acceptable, but follow the indication if possible. 6-5. Powering sequence Make sure the power is removed before the installation. [. . . ]