User manual VITEK VTD-C410

[. . . ] VTD-C410 High Resolution Color Indoor Dome Camera LIMITED LIABILITY WARRANTY VITEK Your new Camera is guaranteed to be free from defects in materials and workmanship for a period of two years from the date of purchase. The product must have been used only for its intended purpose, and not been subjected to damage by misuse, willful or accidental damage, caused by excessive voltage or lightning. [. . . ] The following adjustments may be made: Dip Switch Adjustments Dip Switch 1 = Electronic Shutter Control Leave this switch in the "Off" position if your camera has an auto iris lens. Switch to the "On" position when using a fixed lens version to enhance the camera's ability to react to changing light. Back Light Control Leave this switch in the "Off" position if your camera is being installed outdoors or if the installation is indoors in a controlled lighting environment. Switch to "On" position when installing the camera indoors looking toward windows or doors or if outdoors looking into semi-direct sunlight. Never install camera looking into direct sunlight. Dip Switch 2 = Dip Switch 3 = Flickerless On/Off Flickerless shutter speed for minimizing image flicker under fluorescent lighting. Auto White Balance Switch "On" if the image appears discolored or floats between colors. This will enable the camera to find "White". Dip Switch 4 = 6 3 DOME SPECIFICATIONS Image Device Effective Pixels 1/3" Color CCD Image Sensor 768 x 494 480 TV Lines 0. 7 Lux at f1. 2 (AGC On) More Than 48dB (AGC Off) 1/60 ~ 1/100, 000 Sec. Auto White Balance (AWB) 3. 6mm Included (2. 9 / 6. 0 / 8. 0 / 16mm Optional) Composite: 1. 0 Vp-p / 75 Ohm 12VDC / 24VAC 4. 73" x 2. 96" / 120mm x 75mm (W x H) 0. 66 lbs. / 300g WIRING CONNECTIONS The VTD-C410 Dome Camera should be powered by 12 Volts DC or 24 Volts AC. You should make sure that the power supply you are using is CSA Certified Class 2 Power Supply delivering a minimum of 2. 5 Watts. For optimum video signal, use 95% copper shielded coax cable. Twisted pair or CAT-5E cable may also be used with optional VT-TR1M Passive Video Transceivers. [. . . ] If the camera view is obstructed by scratches, remove the front plate (bezel) and rotate the bubble to a portion that is not scratched. If the dome becomes damaged or scratched beyond use, contact your distributor to order a replacement. Focus Adjustment 4 5 [. . . ]