User manual VITEK VTD-VPH

[. . . ] All VTD-VPH domes feature Sony Super-HAD and/or Ex-View Technology with Hi-Resolution of 480 Television Lines. CONTENTS OF PACKAGE · One Fully Assembled VTD-VPH Series Dome Camera · One Additional Knock-Out Plug · One Tamper-Proof Wrench · One Rubber Sealer Mat · One Instruction/Installation Manual · Assorted Additional screws for Convenience INSTALLATION OVERVIEW Your VTD-VPH Dome Camera is designed to be flush or ceiling mounted on a wall or ceiling and comes complete with a surface mount rear casing including conduit knockouts. Its patented 3-axis gimbal allows for perfect viewing angles on any vertical or horizontal surface. An optional goose neck wall mount (VT-VPHWM) is available if desired. [. . . ] Continue by removing the tamper proof screws on the inner casing (you may want to remove and set aside the polycarbonate bubble to avoid scratching it). Remove the inner casing from the outer surface mount casing (back box) and temporarily set the inner casing/camera to the side. Secure the outer back box directly to a wall or ceiling using wood screws or anchors. If installing outside, remember to glue the rubber matting to the wall and then attach the back box. Conduit may be attached to the rear or the side of the back box depending on the installation. Re-secure the inner casing with the camera to the back box but remember to attach the wiring before doing so. You may also want to find a desirable angle of view and adjust the iris and focus before making the final wiring connections. 3 CAMERA SETUP Your VTD-VPH Dome Camera has been set at average default settings from the factory so the performance should be excellent right from the start. However, certain challenging environments may require additional set-up procedures to enhance the image. DIP SWITCH SETTINGS There are four dip switches on the rear board of the camera. They should all be set to off from the factory. The following adjustments may be made: Dip Switch Adjustments Dip Switch 1 = Electronic Shutter Control Leave this switch in the "Off" position if your camera has an auto iris lens. Switch to the "On" position when using a fixed lens version to enhance the camera's ability to react to changing light. Back Light Control Leave this switch in the "Off" position if your camera is being installed outdoors or if the installation is indoors in a controlled lighting environment. Switch to "On" position when installing the camera indoors looking toward windows or doors or if outdoors looking into semi-direct sunlight. Never install camera looking into direct sunlight. Dip Switch 2 = Dip Switch 3 = Flickerless On/Off Flickerless shutter speed for minimizing image flicker under fluorescent lighting. Auto White Balance Switch "On" if the image appears discolored or floats between colors. This will enable the camera to find "White". Dip Switch 4 = 4 AUTO IRIS LENS ADJUSTMENT Your DC Auto Iris Lens should be set properly at default from the factory. [. . . ] The product must have been used only for its intended purpose, and not been subjected to damage by misuse, willful or accidental damage, caused by excessive voltage or lightning. The product must not have been tampered with in any way then the guarantee will be considered null and void. This guarantee does not affect your statutory rights. [. . . ]