User manual VITEK VTM-14A

[. . . ] REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. NOTE : This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference with radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] 7) Water and Moisture Do not use this product near water, for example near a bath tub, wash bowl, kitchen sink, or laundry tube in a wet basement or near a swimming pool and the like. 8) Accessories Do not place this product on an unstable cart, stand, tripod, bracket or table. The product may fall, causing serious injury to a child or adult, and serious damage to the product. Use only with a cart, stand, tripod, bracket or table recommended by the manufacturer, or sold with the product. Any mounting of the product should follow the manufacturer's instructions, and should use a mounting accessory recommended by the manufacturer. 9) An product and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the product and cart combination to overturn. 10) Ventilation Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of the product and to protect it from overheating and these openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug or other similar surface. This product should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer's instructions have been adhered to. 11) Power Sources This product should be operated only from the type of power resource indicated on the marking label. Adjust only the controls that are covered by the operating instructions as an improper adjustment of other controls may result in dam-age and will often require extensive work by a qualified technician to restore the video product to its nor-mal operation. e) If the product has been dropped or damaged in any way, and f) When the product exhibits a distinct change in performance - this indicates a need for service. 22) Replacement Parts When replacements parts are required, be sure the service technician has used replacements parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may results in fire, electric shock or other hazards. 23) Safety Check Upon completion of any service or repairs to this receiver, ask the service technician to perform safety checks to determine that the product is in proper operating condition. 24) Wall or Ceiling Mounting The product should be mounted to a wall or ceiling only as recommended by the manufacturer. 25) Heat The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat. 2 3 FRONT PANEL CONTROLS REAR PANEL CONNECTIONS 1 2 3 4 5 6 7 8 VIDEO INPUT The Video button changes to A and B and it changes input mode. SHARP The Sharp button controls the frame of the screen. Select the Sharp button to control the frame of the screen with the Volume (Data) button. (50 is the normal size) BRIGHT The Bright button controls the brightness of the screen. Select the Bright button to control the brightness of the screen with the Volume (Data) button. [. . . ] It is same for connecting to the "B" output connectors. You can connect a monitor instead of VCR. To compose Video and Audio, connect Video A to Audio A and connect Video B to Audio B. (See page 4) VIDEO INPUT/OUTPUT Connectors Video input/output connectors are for video signals. [. . . ]