User manual VIVANCO ULTRA FLAT 3 IN 1 UNIVERSAL REMOTE CONTROL

[. . . ] to check functionality , press the PWR button. If everything is correct the red lamp flickers when the button is pressed. Dispose of used batteries according to the manufacturer's instructions. Adapting to appliances In order to control your appliances you must adapt or set the remote control to them:. [. . . ] You can terminate the mode by pressing any device button. Code search If the brand of your appliance is not in the list or none of the codes given fits, we recommend a code search. To prepare code search, press the SET button, keep it pressed and then press the required appliance button, e. TV, additionally until the lamp (LED) lights constantly. ­ Except when searching for a TV code you can also briefly press the (Play) button and use the Play function to help search and press ON/OFF for testing the next code. Make sure that a tape, a DVD or a CD is inserted in the tape deck, player or recorder. Every 1, 5 seconds, until the appliance, e. Your TV reacts by power off or your DVD player, reacts by Play > button. - If your appliance has switched itself off you must switch it back on again, e. - When your appliance reacts you can also try out other buttons without interrupting the search. If some buttons do not work properly, simply continue searching with ON/OFF or Play. - The UR 03 UF continues with the search at the point where you interrupted it. Automatic code search Your remote control finds the correct settings almost automatically in seconds: 1. switch on the appliance to be controlled. A channel number, for example, appears in the display of your satellite receiver. Then press SET for about 5 seconds until the lamp (LED) starts to blink. Then point the remote control at the appliance to be controlled while the remote control emits a different ON/OFF signal every second. When your appliance reacts, press SET within 1-2 seconds, to end the search. ­ If you ended the search too late, continue to search using the Manual Code Search (see above). Finally, test the control code setting by trying to control, for example, your DVD appliance. [. . . ] Scan: When you press this button a channel-up signal CH+ is emitted every 2, 5 seconds and the following channels are shown one after the other without your having to press a button repeatedly. This function stops when you press any button. For controlling satelite receivers, set top boxes etc, don´t contain volume and mute key functions, then the controller controls TV volume and mute automatically. 7 m Not for 400 kHz equipment 2-year works guarantee Should your UR 03 UF cease to work within 2 years of purchasing you will receive a free replacement from VIVANCO. [. . . ]