User manual VIVANCO UR 5000

[. . . ] The enclosed list gives, for example, the Panasonic Code 2551. Please make sure you have selected the correct list for television sets (TV). Press and hold down P+ and VOL- simultanously for 3 seconds until the indicator led (2) lights up. [. . . ] The standard code may provide most of functions needed, but you may miss some key functions. Or you didn´t find any functioning preprogrammed code for a device, e. You can capture upto 226 key function codes. 1 For learning of key codes you must use a functioning orginal remote controller. Please use fresh batteries for both remote controls. 2 Please point the original´s remote control transmitter LED towards the receiver LED of UR 5000 (placed on top , same as transmitter LED). Distance of LEDs between both remotes shall be approximately 5080mm and must be in straight line of sight. 3 To prepare copying of key functions, press the required appliance button, e. 4 Press and hold down P+ and VOL- simultanously for 3 seconds until the indicator led (2) lights up. 5 Key-in learn code 0000 and the learn icon will light up. 6 Press and release the target key, that you want to learn to (reprogram) (e. You can access "free" keys, if you press Shift key (9) first. Upto 3 pages, accessable by Page key (10), are available for any device for copying original keys. POWER) until the LED on your UR 5000 remote control blinks once and the device icon, e. Then adjust the position of both Remote controls and start capturing the key function again at step 6. 9 Press and release device key for exit of learning mode. [. . . ] - Smart keys1, 2, 3 are directly accessible, for 3 further Smart Action keys Shift and then Smart 1, 2 or 3 must be pressed. Then press a sequence of keys, which shall be output later, when you press Smart 1 , 2 or 3 etc. The led (2) indicator will flash once for each key. [. . . ]