User manual VIVANCO UR 12

[. . . ] Then point the remote control at the device to be controlled while the remote control emits a different ON/OFF signal every 2 seconds. When your device reacts, press a few buttons to determine whether you have found a suitable code. The setting for this device is now completed. If the code you have found does work at all or not properly, press EXIT and DEV SEARCH appears again. [. . . ] Then proceed again as described under 3. Please note: - You can reverse the search direction with the or button if you have reacted too slowly to a response from the device. ­ The Menu buttons cannot by used for testing. - You can interrupt code entry at any time by pressing EXIT. To prepare code entry, briefly press the SET button in the bottom right corner of the keypad, then the required device button, e. A new code if you have activated the code entry lock. Select the brand of your device, in this example Philips, with or . Press a few buttons to determine whether you have found a suitable code. When the code corresponds to your device, press OK and the setting for this device is completed. 4 Then press EXIT several times to quit the setting mode. - You can cancel the lock setting using the same procedure. 7 m Not suitable for 400 kHz devices 2-year works guarantee Should your UR 850 LCD cease to work within 2 years of purchasing you will receive a free replacement from Vivanco. Exceptions: missing codes, deliberate destruction and normal wear and tear of the housing and buttons. Backlight To save battery capacity you can switch off the LCD illumination. To do so, proceed as follows: 1 Press and hold SET for 3 seconds, then set CONFIGURE with the or button. 3 Switch the light ON or OFF using the or button. 4 Then press EXIT several times to quit the setting mode. Adjusting the contrast You can adjust the contrast to improve readability: 1 Press and hold SET for 3 seconds, then set CONFIGURE with the or button. [. . . ] Adjusting the contrast You can adjust the contrast to improve readability: 1 Press and hold SET for 3 seconds, then set CONFIGURE with the or button. 4 Then press EXIT several times to quit the setting mode. Default settings You can reset your remote control to its factory default setting, e. - This function is recommended only in the event of your remote control malfunctioning seriously. [. . . ]